Tezz
Active Member
Not sure if right place to post this, but hear goes onto next niggle
Wiper washers.
Rear was Non operational,
first check washer bottle, bit of crap in bottom, got rid of that, order the spray part from china for £1.50, run system to clean lines, fitted and now all ok.
Fronts however not much info on, they work but only just on drivers side, had a look around thought I just replace, till saw cost!!!
So few questions.
Is it possible to remove and clean them out, then run system to remove any bits and refit.
is it best just to snip pipe and fit after market jet on the wiper arms?
can you fit replacement generic bonnet washers, don't care about heaters ect, as these very cheap.
Particles seam to be issue, looked at size of pipe has anyone fitted a filter to the line? just past bottle to prevent issue, small one like a scooter fuel filter?
Wiper washers.
Rear was Non operational,
first check washer bottle, bit of crap in bottom, got rid of that, order the spray part from china for £1.50, run system to clean lines, fitted and now all ok.
Fronts however not much info on, they work but only just on drivers side, had a look around thought I just replace, till saw cost!!!
So few questions.
Is it possible to remove and clean them out, then run system to remove any bits and refit.
is it best just to snip pipe and fit after market jet on the wiper arms?
can you fit replacement generic bonnet washers, don't care about heaters ect, as these very cheap.
Particles seam to be issue, looked at size of pipe has anyone fitted a filter to the line? just past bottle to prevent issue, small one like a scooter fuel filter?