• The Forums are now open to new registrations, adverts are also being de-tuned.

103

  1. optimusprime

    w124 103 question

    Can some one with more information on this type of car. Question would removing the radiator and water pump for replacement ,drain out all the coolant .Only put 1/2 of the required amount in and it wont let me put the other half in.Looking now as if it all did not all come out when i removed...
  2. optimusprime

    help please torque settings. w124 103

    Can i ask for a little help . New water pump is in the car, and i am about to refit the pullys.I am short of one torque figure .This is the viscous fan assembly.The fan pully i removed to take the belt tensioner strut off. I now want to refit this item but without the settings i am held up...
  3. optimusprime

    torque settings pully 103

    Hi just about to replace the pully on the tensioner on my w124 260e the pully is worn on the face only .Removed the old one .Can you tell me where i can find torque settings for this pully .Only thing holding me up for 2 hours , as i have been looking for the figures. My Haynes Dandy as...
  4. S

    what is this breather tube on a 103?

    I recently saw this photo posted on another forum and spotted a breather tube stretching from one side (near the fuel distributor) all the way round to the other side and disappearing somewhere near the battery. I have two questions for mbclub. 1. What is this tube? 2. Is there a...
  5. nick.ged

    103 inlet manifold

    as the title suggests, i am looking for a 103 inlet manifold, anyone got one avalible?
  6. nick.ged

    unused 103 sensor (cold enrichment)

    when i took my engine out to rebuild it, i broke this sensor off, (see pic attached) so i brought a new one. when i put engine back, i'd changed my plans, and used megasquirt, so the sensor was not used. cost 50 odd quid from mertruks derby. will sell for reasonable offer to get some money...
Back
Top Bottom