bore

For an engine I am working on it appears that I will need something to accurately measure the bore(s) (circa 73mm) (wrt ovality etc) but cannot remember the name of the tool required. Does anyone know the correct terminology? Is the item in the link the thing I need? Does anyone have one that...

Hi. I've just bought some wheels for my w164 ml which came off another ml of the same year. But for some reason the hub on my car doesn't reach the centre bore of my wheel. I'm assuming you should probably have a good 5mm inside to take the weight of the car. Can I cure this with hubcentric...

Hi all, I've done a quick search and not found the diameter of the bore on the exhaust for the C320.. I know that I could go out and measure it, but I'm too lazy and its too cold lol.. Anyone here have any idea what it is? Cheers, Mandip

Hey y'all. Purely out of interest, anyone know what displacement the M110 can be bored out to? How strong are these blocks? and if anyone has done it, was there any power gain at all?

Hi all. Ive been having a problem with my car lately. its been very lumpy at idle. 6 months ago all injectors where cleaned and car was running fine. the lumpiness has returned. Ive cleaned EGR and changed fuel filter and put new copper seals in the injectors. i also had to clean up some oil...

Pair of Hubcentric 20mm wheel spacers 5 stud 5x112PCD 66.6 centre bore, Mercedes etc. Brand new and unused, bought these for my Mercedes CLS when I bought 20 inch wheels for it, but never got round to putting them on then sold the car. So these have been sat in the garage since. £60 + P&P...

Few questions :confused: that i hope you can help with. :) Looking to get some alloys for a Honda that we have in the family. Been told i need the following: PCD : 5x114 Offset : 38 to 45 Bore : 64.1 What does the offset range mean? I can have anysize alloy aslong as the offset is in...