cps

Problem occurred twice whilst driving (lost all power) but car re-started immediately, unfortunately now it's gone terminal! No warning lights on dash - don't know if any error messages have been generated (don't have a reader). Suspect Crankshaft Sensor or Immobiliser is faulty. Whilst cranking...

I seem to have got the 300 to a point now where it will start and run fine when cold, but after 10 minutes or so of driving, it starts to missfire under acceleration, stall at junctions and have lots of difficulty restarting. The flasher diagnostics are still reporting the CPS as faulty, despite...

Vehicle 2.0 facelift w202 Had my stored fault codes read and cleared and the only one to return is Crankshaft sensor saying something like incomprehensible. If I get in my car in the morning and drive the 28 miles to work the car drives fine and the same on the way home, but if I have to stop...

Hi Folks, After having problems with my car stopping and not restarting until the engine had cooled I decided to change the CPS sensor. I removed the screw but the sensor is stuck in the bell hosing. I have tried WD40 but it will not budge. I spoke to a local garage and they say they would have...

Any tips how to gain access to the cps on a 2001 c320? Ive had a look underneath and from the top and cant even see the thing, i can just see the plug that goes into the cps but its shrouded in other looms. Ive had my arm up from underneath and can just touch the plug but cant even feel the...

went and removed the crank sensor on my 1998 w210 e320 and it snaped off half way out :mad: is there any way to get it out or push it though without haveing to take the box off

anyone got any info on changing one?

hi chaps i want to change the crankshaft position sensor on my 1993 500 sec (w140).. how hard is it to change.... what is the procedure... i have a heavy duty trolley jack and axle stands... thanxs