• The Forums are now open to new registrations, adverts are also being de-tuned.

Parktronic Problem Code 9041

UKCCE

Active Member
Joined
Feb 2, 2018
Messages
68
Location
Essex
Car
CLS 55 AMG
Hi all my w219 CLS 55 parking sensors are not working had it scanned and it came back with

9041 - The supply votage of the sensors at the control module is out of permissible range

Any idea where to start ?
 
Is that read using STAR?

Check condition of each sensor loom connector
 
9041 The supply voltage of the sensors at the control module is not within the permissible range. STORED 9003 A42b1 (Left outer sensor, front bumper) : The plug connection has poor contact or is loose, or the sensor or cable is faulty. Current and stored 9006 A42b2 (Left center sensor, front bumper) : The plug connection has poor contact or is loose, or the sensor or cable is faulty. Current and stored 9009 A42b3 (Left inner sensor, front bumper) : The plug connection has poor contact or is loose, or the sensor or cable is faulty. Current and stored 900C A42b4 (Right inner sensor, front bumper) : The plug connection has poor contact or is loose, or the sensor or cable is faulty. Current and stored 900F A42b5 (Right center sensor, front bumper) : The plug connection has poor contact or is loose, or the sensor or cable is faulty. Current and stored 9012 A42b6 (Right outer sensor, front bumper) : The plug connection has poor contact or is loose, or the sensor or cable is faulty. Current and stored 9015 A43b7 (Right outer sensor, rear bumper) : The plug connection has poor contact or is loose, or the sensor or cable is faulty. Current and stored 9018 A43b8 (Right inner sensor, rear bumper) : The plug connection has poor contact or is loose, or the sensor or cable is faulty. Current and stored 901B A43b9 (Left inner sensor, rear bumper) : The plug connection has poor contact or is loose, or the sensor or cable is faulty. Current and stored 901E A43b10 (Left outer sensor, rear bumper) : The plug connection has poor contact or is loose, or the sensor or cable is faulty.
 
Don't discount the wet/cold weather. These sensors sometimes cause problems when jet spraying the car. Select the switch off until the temp rises in a couple of days then try again maybe?
 
onefortheroad it did have all the codes for all the sensors like that but when cleared only came back with the 9041 code guessing it the main parking module any one have a clue where it is as cant use the search function on here as its broken atm
 
esscee its been like this since the last owner had it so over a year so i don't think the cold will be the problem as was same all last summer
 
A 219 545 07 32 is in the boot , left hand side .
 
cheers will have a look at the weekend
 

Users who are viewing this thread

Back
Top Bottom