bushing

On several websites (e.g. Problems and recalls: Mercedes-Benz W204 C-Class Saloon (2007-11) | UK Car Reviews and Buyers Guide, Images, Videos, Recalls, Faults and Problems) it says that: 'Mercedes-Benz W204 C-Class: other problems and faults Knocking noises from the engine bay during low speed...

Hi I have just bought a Ml320 w164 and need to replace a bushing in the front subframe, do I need any special tools before I tackle it ? Cheers Hog

Hi all, my brother in law (who is a very experienced in dependant mechanic) has followed the guide in the how to section for replacing the ATF, filter etc on the above box which is in my wifes 54 plate W203 Sports Coupe. In post 4 of the guide "olly" mentions that the pivot bush leaks sometimes...

Hi I noticed while changing the rear flexi disc that the centre bushing that locates on to the rear differential is needing replaced. Does any one know how to change one of these? I need my car for work and cannot afford to have it off the road for longer than a weekend. Any information on...

For sale is a GENUINE Mercedes Benz tool set (part number: W202 589 00 43 00) for removing and replacing the wheel carrier bushing at the rear wheel carrier assembly (where all the links attach). This is in pretty much as new condition as it's only been used once to change the bushes on the...

As per the title, does anyone know what this part actually is? Thanks Rob

Some will have seen that I've just done a transmission fluid change on my 722.6 gearbox. Intending to change the pilot bushing to avoid the 'gearbox loom and ECU full of oil' problem, I undid the 7mm centre bolt, but could not get the old bushing out, so left well alone. (I didn't want to use...

Since I'm under the thing doing the transmission fluid change, I might as well change the pilot bushing as a precaution. Is it the outer O-ring that causes the leakage problem, and does anyone know if there is a tightening torque setting for the little securing bolt in the centre? E55BOF

Need to replace the outer bushing in both spring control arms in the rear. But when I have the control arm loose it looks like it is made of two pieces and that the bushing is not possible to replace. Also the new bushing is 40 mm vs the hole in the arm which is 38 mm. Is it true that I...

Traced the trans fluid leak on my C250 to the multi-plug. Box behaved normally despite having lost nearly a litre of fluid over the last 10k miles. Its been kinda oozing away. The fluid, filter and sump gasket were all done 10k miles ago, so I'm just doing the multi-plug and getting the fluid...

I'm doing an ATF change over the weekend and have bought a new pilot bushing in case it's found to be leaking. What's best practice: If the one fitted is bone dry, should I leave it be ... or fit the new one anyway? Last time I did an ATF change (on my previous car, a C250) it wasn't...

Hello I was hapilly changing my ATF of the '02 C270 and went on to replace the pilot bushing. No oil on the outside but when removed, it was showing signs of a leak. There was oil on the inside! Not much, but present. What to do? Should I tear the electrohydraulic module apart and clean...

My '02 C32 has bad creaking from the front suspension when braking hard or going slowly over bump. I just replaced the end links and the noise are somewhat improved. But I can't figure out the correct part number for the sway bar bushing.. According to EPC with my VIN, it says my sway bar is...