closes

My W212 has started lifting the load cover to the upper position once the hatch has closed. Anyone else had this problem and know of a solution? Even if the cover isn't pulled across, the motor still runs and lifts the tracks up after the hatch is closed Sent from my A0001 using Tapatalk

Hi, A few threads on the subject but hoping someone might spot something 'obvious' for me to investigate. The load cover rails are 'stuck' in the down / closed position and won't open / release when I open the boot. Tried so far: > Remove fuse > Check position of magnet sensor > Reset rails...

I know a few of you, have used this company, myself included, authorised Kleemann installers amonst many other things, they rolled out of one scandal a few years back to form CPR, seem to have recovered, only to what appears too be sold down the river by the directors, again, heres a link to one...

Unfortunately Channel 4 has chosen to close its 4car website. It was a very useful site full of reviews and news reports but without a TV programme at its core its days were numbered. :( The Platform4 blog - 4Car has closed

Hi all, My drivers side front window on my 230 CLK Cabrio (2000) seems to have started closing too far. I noticed when I started finding the door difficult to close and the window not laying flat against the rear window seal. This leaves a gap between the two windows until I open and close...

Soft-top unlatches and starts to fold away, but the two support rods (each with a small rubber pad on it) now stay upright making it impossible to complete the fold-away operation; they stop the clam-shell being able to fully close. If I reverse the operation and open the hood half way up, I...