Need some clarification please. My W210 normally starts first time, every time but recently if left for a day (flat surface) it takes 2 or 3 attempts but is fine for the rest of the day. Clear fuel lines are around 2 years old so not those but reading about it, this is common and the seals need...
The car's MOT'd and a runner but it has too many W210 challenges. Plus they're worth slightly less than sod all now.
Hence I'm thinking of breaking it; 150K OM613 engine, 722.6 box, grey leather 7 seat interior, 744 Silver bumpers, tailgate etc. Large items basically.
Parts will be cheap...
I took it into a garage, they say there is a low flow on EGR as one of the diagnostic faults.
I drove the car 20 miles after clearing the diagnostics, it went like **** of a stick, and then, it went back to its silly slow self.
The 2 things that they put on the invoice are;
P0105 B5/1...
:wallbash:OBD1:wallbash:OBD1:wallbash:OBD1
Guys and Gals
I have been going mad trying to figure out whether its possible to get a conversion done on a e320 cdi with OM613 motor on 2001 year.
The problem is that I desire to use the OBD2 type bluetooth scanner to build a digital dash based on...
Hello
I think I have a bad bearing on the waterpump and I am in process of replacing it. Unfortunately I can find away to lock they pulley so I can undo the 8mm hex bolt holding the viscous fan. I have no bolts on the pulley and I can't find any hole to lock it.
Om613 320 cdi straight six...
I’m getting into my E320 S210 and need a workshop manual, not a Haynes they skip over things deemed too technical, I’m a competent mechanic and need procedure and specs workshop rather than a home DIY, there are a few on eBay/Amazon any recommendations/warnings?
2002 320CDI (OM613).
I started my engine last night (it had been running for 15, miles 40, minutes before that) and it was a little hesitant to fire up (as though started without waiting for heater plugs to get to temp) and although not too noticeable, ran as though missing a beat on...
Good afternoon.
I need to remove the fan from my 320CDI (OM613) engine.
It's a tight squeeze and other than using a long allen key, I don't have anything small enough to fit into the aperture.
Can anyone recommend a slim ratchet that will accept screwdrive bits so I can avoid scraping my...