pressing

I need advice with installing bearings into 124 estate rear hubs. All parts ready on the bench. Do I press in the bearings into the hub carrier then the hub into the installed bearing? This seems the logical way to do it but just wanted to check before I started... The hub carrier is...

Just had an issues that I hope is very minor. Car was cool to warm. Started the engine and all was fine, no warnings and it sounded normal. As I was getting out of a long car park I didn't really give it any gas. When I tried to give it some gas the car did not accelerate any more even...

Hi there, Newbie to the forum so forgive me if this is obvious. As per the post title my E320 CDI (2001) Avantgarde has an intermittent fault where the engine revs drop momentarily when driving, knocks out cruise (it will re-engage) and flashes up ABS BAS "Visit the workshop" lights. Then...

...and the engine goes to a lower idle. When i release the clutch, the sound goes away, and engine idle is back to normal. I'v used the car daily for a while. Any ideas what this is? Thx, davelarue

I'm looking to get a low volume of steel parts either spun or pressed. I suspect making a press tool will be prohibitively expensive, hence the spinning. Does anyone have any contacts for low volume spinning and laser cutting?

hi Wheat can be the cause of rattling noise on pressing and realsing accelarator. this rattling is audible on both D (fwd) and R (reverse) only on slow speeds. Location of noise is from underneath the accelarator. Plz help Regards

Hi, I am looking to buy a 1982 W123 240D Manual Estate. The bodu is mint and it seems to run really well. However, when I press the clutch a loud squealing noise comes from the engine (similar to a fan belt squeal if you know what I mean). The guy I'm buying it off claims that this noise is...