valves

My valves are a bit dirty/corroded/generally pants and letting down my otherwise perfect CL55. Can they be replaced easily without affecting the tyre pressure monitor device on the inside of the wheel ? My local KwikFit says they can't. If they can be unbolted from the outside and replaced...

Bosch Automotive Tradition - Parts - Current reproduced products Very welcome news for the older MB owners amongst us :o No idea on pricing/availability etc, but I imagine a local Bosch agent/service centre would be able to advise :) Will

Is it a good idea to stop the EGR Valves? Will the engine run better/ longer/smoother with no hot/used gaz coming in? And how to block it? Than you. Olivier

When I bought the car the heater temp was full hot, this forum gave me the know how to strip/clean the duo valve. Been perfect up to now, now its back to full hot. I thought the duo valve would be ok so I've been checking other stuff, fuses, cabin temp sensor and vacuum, heater controls etc...

I've been trying to resolve the temperamental heating in my 300E. It doesn't always blow cold. Hot is no problem but when switching the dials to cold, warm is the best i can get. Sometimes it will stay on hot. I've had the duo valves apart and clean up all the parts (twice) and initially it...

http://v12uberalles.com/Rear_AC_System.htm

Whilst driving on motorway I suffered a loss in performance, clouds of black smoke when accelerator pressed, took car to MB non approved garage.Initial inspection thought air masss sensor had gone, car reprogrammed air mass sensor fitted but fault remained. Further investigation req'd...

how easy is it to change the oil stem seals on a 2.3 16v 190e as i had to tak the head of because of no compresion in one of the pots so i though over haul of the haed as it is of. Plus i have very bad pitting on the face of ihe inlet valves an very slight pitting on the seal edge should i...

Hi all, Just a quick question. I've been running around the office here boasting about my recently purchased S class. It's the 4.3 litre V8. I've been saying that cos mines a V8, it's got 32 valves. But looking at the tech spec on Parkers website, it says the V8's have 24 valves. How's...

My cylinder head has to be replaced as a result of failure of the gasket caused by a sticking valve. Is this common on a 2003 model C200K. The stealer has been unable to get MB to pay for any of the cost!

hi all......newbie 1989 w201 190e 2ltr manual driver here 1) pleased as punch with my black ride....and have blinged it to the max....but tastefully...( proud pic to follow shortly)....however may have blinged it too much for someones taste coz they busted off the hood star.....lm looking for...