hi keep getting codes up p0172/p0175 on my c280 2007 v6 petrol changed air filters,plugs ,maf sensor,no vacuum leaks i can see. any ideas what it could be.
,,,,,Without the diagnostic tool? I.E disconnect the battery for 30 mins or is it a case of having to use the tool, and can you read the codes by flashing them off with a wire link like you can on a Vauxhall?
i have just got back from the garage and the esp/bas fault has 2 codes showing
C1200 STOP LAMP SWITCH S9/1 PLAUSABLITY
AND
P1584 STOP LAMP SWITCH
I HAVE CHANGED THE SWITCH BEHIND THE BREAKE PEDEL AND THIS IS STILL COMING UP. ANY IDEARS.
MARK
Hi Guys, I have some problems with the Wife's 2000 Mercedes A190, auto, petrol, when it is cold say if it is standing overnight in the garage it takes forever to start, it cranks over about 7 times before starting, it first sputters a bit on say the 5th turn, then on the 7th it wil start and...
Hello, I am hoping to find some help here regarding some issues with my 05 C220 CDI.
I have found that if I drive below 60mph all seems well, once I break the 60mph mark the car will go into limp mode, up to 60mph she will rev through 3000rpm as normal.
I have NO eml light when this happens and...
Been to Advance Vehicle Centre and this is the diagnosis.
perm fault codes in ABS C1025 CAN signal
ASR C1101 RPM sensor F/M
Engine P1335 CPS
P1481 Glow plug device
Can anyone explain them to me? the centre didnt say say anything. Are they serious or can be fixed easily...
On my 1992 300TE 4matic there is an 8 pin diagnostic port next to the fusebox.
I am trying to read out the codes to find out what the big yellow triangle and 4matic lights are on for.
Going by the guides I have found, there are 2 types of diagnostic readers I can make. One has 2 pins, and one...
What post codes should I get on a V10 aps 2009/10 for an ntg1.
Just udated mine from V4 to V10 & there is'nt any difference.(5 spaces)
Although maps much better.
Hi,
I have a w reg a140. it has always shown diagnostic codes when i have taken it to my local garage. Recently wont start, however when plugged into garages diagnostic machine wont connect or show any codes, had another garage bring his delux equipment still wont give up any codes, in fact...
I've a 1999 C230k auto that is giving some fault codes on my EBD reader:
P0170 Fuel (Trim Bank 1)
P0700 Transmission Control System (MIL request) PENDING
P0170 Fuel (Trim Bank 1) PENDING
In English, what does this mean?
I've had the car about 2 years and have cleaned the MAF and air...
Hello members,
I have a bit of trouble with a misfire on my 94 E200 111940, I have been chasing electrical problems for a while now, have gone through the usual remedies like fixed wiring loom, changed OVP relay for abs light on, new plugs, but there is still a misfire developed just recently i...
went to merc with a dueliner i want to buy. its a 04 plate with engine management light on. they plugged it in for me whilst i went to shops. time i got back techs were gone.
got a print out of all faults and dont know what they are.
2514-001 component R39/1( vent line heater element) does...
Hi
Are fault codes read with SDS and Carsoft the same? When I scan my car with Carsoft I get a few codes that I can't find much information on.
B1268
B1887
C1026
Hi All,
I am new to the forum. Hoping some of your experties may help me identify my issue.
I have a 2004 C270 CDI. My engine management light (eml) came on a few days ago. I took it down to my local Benz specialist (not MB) and he ran a diagnostic on the the car; diagnostic showed no...
Any one had any experience with Black Codes, not sure if the right route to take however could be a good location for a group re-map and would save driving all over the country to get a good job and a good deal.
Fellas! What do you think?
Oh and if MB rewrite on service they will redo...
A few weeks ago I saw a list of W model codes correlated to build dates and car types but can’t find it now. Please can someone point me towards it.
Thanks.