injectors

would these injectors injectors work on a 2000 reg merc c220 cdi? mercedes c220cdi injector 2007,6460700787

As per title, but this is carbon built up on the outside from when an injector seal leaked, The garage cleaned the one they worked on, but left the rest as they were (a bit sloppy and unprofessional in my opinion) So there is still the sticky black mess all over the other three injectors, the...

Can anybody recommend somewhere that I can pick six fuel injectors up? Merc are quoting me just shy of 200 a piece. seems high. not sure of Part No... does 0445 110 034 sound about right? are they cylinder coded by the way?

Hey everyone,I had a starting problem on the weekend which turned out to be 3 of my 6 injectors leaking. Today the local specialist replaced them and when I drove home noticed that there was an awful lot of smoke from the back and that the car was down on power.I specialist has it again now to...

Our MB got lost over the weekend. After a trip to the garage for wheel bearings it never returned - at least in part as the wrong bearings were supplied initially. Chased it down today, to find that the mechanic had discovered yesterday that one of the injectors was blown with a fair amount...

No 1 injector on my E 270CDi is goosed. Just been told by Bosch they won't have any ready till December as they've had a run on them. MB want £400 for one. Is there anywhere else I can get one?

hi im looking for injectors for a 1971 300 sel 3.5 they are the yellow ones part number 0280150034 has any one got any or any ideas where i can get any. ive allready ought 2 that are unservicable and dont seem to be having much luck stateside HELP!!!!! :wallbash::wallbash::wallbash::wallbash:

Hi all I'm back again with the same problem on my dad's ML270 W163. it struggled to start during the winter. I had a Mercedes roadside assistant come over when it was snowing and he changed a couple of O rings to the pipes going into the HP fuel pump. After cranking the car for while with...

Hi to all. I've recently been experiencing a problem when driving my merc. I'll try to explain as best I can. Whenever I push the accelerator pedal for more power the pedal shakes slightly, enough to notice, and then picks up. It happens on flats as well as on a steep hill, there is no...

Took the black cover off from the engine today to give it a good clean as it had faded. I found some oil around around the casing. Looks as if the end one is messiest(as pictured), then gradually gets better, until the last 3 are spotless. E300td straight 6 by the way. Just wondered if...

Hello all, i have a 1999 Mercedes Vito 108 CDI 2.2. It was smoking (Blue) on cold start and running very rough. I was advised that injectors would be the problem so i changed all 4 injectors and tried it again.... Still smokes like crazy on start up but it goes alot quicker now and the smoking...

Hello all Some time ago I posted on here with regards to the wells that the injectors sitting in were full of diesel on my 1997 W210 E300.To my shame I have just continued running the car with the problem as it ran OK,but now the leak appears to have got significantly worse.So much so that when...

Dealer tells me it is a 'glue' failing within the injectors. I know that glues/adhesives are quite spectacular in their performance i.e. aircraft, rockets etc are held together by them but was this this a problem from the outset or did it occur at a certain point? Does anyone know when...

Hi folks Looking for a fuel line pipe it has 4 plastic ends where it attaches to the injectors or if someone can supply me the seals? Email or PM through profile if anyone can help thanks

My big silver bus is struggling to start from cold. It turns but sounds like there's no fuel getting to the engine. The only thing that makes it fire is a spray of Bradex Easy Start. I had a couple of injectors go a year a go at 110k miles and this seems indicative of that problem again. I'll...

Anyone got an ECU for a 1973 W114 280ce - Djet? Might be looking to replace the injectors too! They're green but unfortunatly im away still until next week (hence i havent been on here in a while - no internet connection) so im not sure of part Nos etc! Any help would be great! thanks alot and...

my 89 e300d sounds like a steam engine :eek: No1 & No6 injector ar blowing alot of cumbustion pressure up past the injectors, :( so might pull the inlet manifold off as i have 6 heater plugs to fit anyway, anyone any tips for removal of injectors? im gonna get them tested as i suspect they'll...

Hi, has anyone refurbished injectors on OM603 engine?? how much would it cost??

Does this have to be done by STAR ??? or can they be just installed and away you go ? If by STAR, can this be done by other diagnostics ?? What are the implications if STAR isn't used ??

Hi All, I recently aquired one of these with 86k on it and a very clean example. Unfortunately I have ended up spending on it none stop and now can't solve one problem. Firslty, the car wouldn't rev above 3000. I overhauled the intake manifold, cleaned up the flaps and egr while I was at it...