Should my comand have a d2b?

[HughJarse]

As the title says - it doesn't as I didnt fit one? Works perfectly though , with dashboard etc...

If not how do I install a factory CD changer as all the searches Im doing suggest that it connects via d2b?


This is a link Im going off.
http://www.benzworld.org/forums/w203-c-class/1168688-diy-comand-2-0-retrofit-my.html

Thanks for any anwers.

 

[Alfie]

As the title says - it doesn't as I didnt fit one? Works perfectly though , with dashboard etc...

If not how do I install a factory CD changer as all the searches Im doing suggest that it connects via d2b?


This is a link Im going off.
http://www.benzworld.org/forums/w203-c-class/1168688-diy-comand-2-0-retrofit-my.html

Thanks for any anwers.

Your comand is a D2B unit. IT will therefore communicate with a CD changer and factory phone, TV etc. If you have none of these, then it is a fairly simply job to hook a CD changer up to you comand. You need the changer, a short (0.5M) fibre cable and an equally short power/wakeup cable. Plug it in and the coamnd will see it. No coding required.

 

[HughJarse]

I can see that the power wakeup may go on pin 10 of the c2 connector??

But I didn't see anywhere to plug a fibre optic cable?
Should there be a slot, hole? There was what looked like an empty circuit board slot on the right hand side when viewing from the back though.

 

[Alfie]

I can see that the power wakeup may go on pin 10 of the c2 connector??

But I didn't see anywhere to plug a fibre optic cable?
Should there be a slot, hole? There was what looked like an empty circuit board slot on the right hand side when viewing from the back though.

The power goes to c1 pins 5 & 6, the wake up goes to Pin 10 C2.

The fibre optic goes into the angled slot to the side of the fuse on the rear. there may be a green protector plug in the slot.