• The Forums are now open to new registrations, adverts are also being de-tuned.

W203 Car Wrapping DIY

varangy

New Member
Joined
Apr 6, 2015
Messages
11
Location
Norwich
Car
Mercedes Benz C180 Sport Coupe
Hi guys

Just I would to making a car wrapping around my lovely merc, some similar that U see on the photo below.

7f0792a205ca9295c98cbd6c09cfaaa8_zpssrlc7wwr.jpg


What you think guys, can I do these works myself with a decoration routine? Actually, I never did this, but I had a permanent job on the graphics and design factory, before few years ago, and had a lot of different outdoors job, with similar foils. So is not a first time than I meet with this foils.
Can you give any advise, how to do, what the level of the difficulty of these works, please?
Any cold and warm advise will be appreciated :)
Thanks and the stars be with you :)
 
Yes, it's amazing.
Just Im find a cheap solution for wrapping, instead an expensive 3M and Avery foils, can U see here. ;)

The foils will be cheapest than £150 all together, what is needed for an average size cars. ;)
 
Yes ! Do it !

What could possibly go wrong ?
 
Dont buy cheap wrap as it is impossible to put on correctly especially if there are a few contours.

It is hard enough to do properly so get the decent stuff and give yourself half a chance.

Kenny
 
@kenny, I don't see any standard chrome/silver look wrap, can you point my in the right direction? I have two 1950s bumpers to wrap, to chrome them will be the thick end of a grand!!!!

Thanks

P
 
I was just after looking at that, I'd need two metres then, bumper about that length and get the two of them done if 1.52 m wide, £38 versus £1000!!!

Cheers


P
 
I was just after looking at that, I'd need two metres then, bumper about that length and get the two of them done if 1.52 m wide, £38 versus £1000!!!

Cheers


P

I think, they can provide continous lenght untill 50m, as the max size of the reel. ;)
 
I have a professionally applied Matt aluminium wrap on the roof of my Subaru. Three years on it looks terrible. It has badly stained and discoloured in patches. No-one can offer any advice on how to clean it and I will probably have to remove it. Looked good to start with but In the long term a complete waste of money an time
 

Users who are viewing this thread

Back
Top Bottom