• The Forums are now open to new registrations, adverts are also being de-tuned.

W211 E220 CDI no start, STAR errors

paalw

New Member
Joined
Nov 23, 2015
Messages
11
Car
E220 CDI 2003
Hi, I'm new to the forum trying to find some help.

My car (W211 E220 CDI, 150000 miles) suddenly won't start, just cranks but no start. No errors in displays or anything. Started fine 2 hours before.

Ran a STAR test and these errors came up. Are there some good STAR interpreters here?

Attached star errors:
 

Attachments

  • STAR_ERRORS.jpg
    STAR_ERRORS.jpg
    68.1 KB · Views: 29
I ran another diag test with the diesel pump disconnected, I then got the exact same errors + a couple of new errorsregarding the tank level sensors(which I guess are the 3 other (thin) wires on the connector).

I then put a multimeter on the two thick wires to the pump, and measured while turning ignition. No voltage.

Then checked fuel pump relay in trunck for click, yes it clicks when turning key both ways.

20A Fuel pump fuse is ok, but when measuring voltage there while turning ignition there is nothing happening there either. So. Thats where I'm at now.

Is there a main fuse another place, or something else that could cause this no voltage situation? Doe this make sense at all? Wouldn't a bad wire somewhere just blow the fuse? *conFUSEd* :p

Anyone?
 
Correction: When I measured V on the fuse inlet i did it wrong way. I put + and - in each of the fuse holes. Obviously thats not gonna give any answer. So please discard information regarding 0 V at fuse. I will measure again tonight. Though the measurement of 0 V at the pump should still be valid.
 

Users who are viewing this thread

Back
Top Bottom