cover

Do I need to use a torque wrench for the nuts when changing the valve cover gasket or can I just do it by 'feel' ? :confused:

Can anyone recommend an outdoor car cover? Mainly for dust/prevent scratches etc as current car has a few from neighbours/rubbish collection/kids etc (lives in small mews)

Hi, Bit a of a daft question but does anyone know how to remove the engine cover on a W212 E350 cdi please. Looking to do a DIY oil change at the weekend and need to get to the oil filter. Assuming it just pops off but not sure how to disconnect from air intakes at the front. Anyone know...

My E55 W210 facelift model is missing the passenger side front jacking point cover! They cost £40 + vat from Mercedes so unless I can find one elsewhere I will just have to order one from them. Happy to pay a reasonable price if anybody has one to sell! Cheers in advance Pat

Did a service on my mum's neglected car. Noticed this oil. See attached pics. Please advise. Sent from my GT-N7100 using Tapatalk

Hallo everyone wondered if anyone has experienced the same issue. Two weeks ago on my C63 I experienced some sticky stuff on the engine cover which I whipped off. Now two weeks later they seem to have returned and not sure what it could be and from where. Any ideas would be very appreciated.

Came out of my brabus w163 ML which I forgot to put back in. In nice condition. First reasonable offer takes it.

Transpires that I wasn't really using any buttons on my key fob and not actually using the key as a key and didn't actually insert it anywhere :D Just stays in my pocket. So I got a leather cover for about £3.99 off ebay to protect it from key scratches. Seems to be a good and snug fit...

Just been on Gumtree , this Sahara car cover is for indoors only. I have one but an outside cover .Really well made The location is Derriford in Devon .Check it out item number is 1158286124 price £25 .If you in the location and need a cover for your W124 convertable it would be cheap . Over...

Recently purchased a whole load of CTEK extras including this bumper / protective cover. However, purchased it for MX7 which it does not fit. If you have a 3.6m - 5amp model it will fit fine.

Hi there does anyone know the part number for sliding door step covers on a w639 vito and roughly what they cost

Hi, Following my last post I'm looking for a luggage cover guide rail for the left side as I think slamming the boot has knackered the sensor and it doesn't recognise when it's lowered the cover and continues trying to lower it with a horrific crunching noise. Looking for one in cream as...

Hi, I am new to the forum and have so far gained a lot of knowledge from your excellent community and hope to share my experience and knowledge with issues and repairs. I am having an issue with the retractable boot cover of my 2004 E270 estate. When I open the tailgate, the cover retracts...

Hi guys had a quick search and couldn't find anything, back in the day 2-3 yrs ago when I had an RS Focus, there was somebody on the forum who made a bespoke seat cover tailored to fit the front seats exactly just to protect them from the dangers of everyday use. Does anybody know of anyone who...

Not huge, but noticeable nonetheless - about 2mm difference between the left and right hand sides: I looked at glovebox removal WIS page - AR68.10-P-1400AK - but there's nothing about adjusting the hinges, which I presume, and hope, is possible? Adjusting the little rubber buffers on...

In the problem zone again.So i am asking if any member can find info on fixing the moulded trim to the trunk lid. My w124 never came with a moulded trim cover,.And as i had seen other w124 with one , so i wanted one . The bootlid is looking cheap with out it. .Ebay was the place i picked one...

Well the title says it all, let me know if you can help Rich

Hello there, Does anyone have a load cover for a 2013 C Class Estate) they would like to sell? Regards P

I've noticed that the front most engine cover retainer is missing from the engine bay, allowing the cover to vibrate at idle slightly. The cover is fine and the plastic screw is still attached to the front edge of the cover, it's just the female receiver for this screw that is missing. Anyone...

I have bought a breathable cover for my new Mercedes-Benz, I have an apartment in Nottingham and a holiday home in Lincolnshire, but "no garage", any advice you could give would be good.......