Hiya,
I have been tryint to access the engineers mode on my NTG2 fitted in my 2005 facelift ML320.
I have followed the instructions but it does not enter the menu. 'On NTG2 modes you can see the Navigation internal menu by pressing NAV, letting go and then holding NAV and the 5 key for about 10 seconds. This may work for NTG1 as-well.
On NTG1/NTG2 you can enter the 'Engineering Menu', firstly go to the language menu by pressing SERV key, then the System soft-key, then the Lang. soft key. Now hold down the 'phone-hangup' key, the small key between up and left on the arrow pad, and the Audio key. This should enter Engineering mode'.
Has anybody else suffered this problem, if so how did you get into the menu?? When i push the three buttons together it just goes to the audio page??
All advice most welcome!!!
I have been tryint to access the engineers mode on my NTG2 fitted in my 2005 facelift ML320.
I have followed the instructions but it does not enter the menu. 'On NTG2 modes you can see the Navigation internal menu by pressing NAV, letting go and then holding NAV and the 5 key for about 10 seconds. This may work for NTG1 as-well.
On NTG1/NTG2 you can enter the 'Engineering Menu', firstly go to the language menu by pressing SERV key, then the System soft-key, then the Lang. soft key. Now hold down the 'phone-hangup' key, the small key between up and left on the arrow pad, and the Audio key. This should enter Engineering mode'.
Has anybody else suffered this problem, if so how did you get into the menu?? When i push the three buttons together it just goes to the audio page??
All advice most welcome!!!
