W202 Bumpers pre marked for sensors

[alanuk400]

I was thinking of fitting front and rear parking sensors to my W202, when I take the bumper off are they pre marked on the inside for them, I did a Rover 75 and they were there.

If I do go ahead, does anyone have instructions for the removal of the bumpers.

Thanks

Alan

 

[NW_Merc]

Is yours a pre-facelift or facelift w202?

 

[alanuk400]

Is yours a pre-facelift or facelift w202?

Sorry, facelift (1999)
Alan

 

[NW_Merc]

http://www.mbclub.co.uk/forums/body...-front-bumper-fogs-w202-not-56k-friendly.html

http://www.mbclub.co.uk/forums/bodywork/47384-how-remove-fit-c43-standard-rear-bumper-w202.html

 

[alanuk400]

Thanks for that, I looked in the "HOWTO" section and couldn't find anything, do you know if they are pre marked for sensors

Alan

 

[Laters]

When I looked on the inside of my bumpers (1998) there were no marks I could see.
Didn't bother me as I fitted the no holes type of sensor (sticky metal tape).

 

[NW_Merc]

Thanks for that, I looked in the "HOWTO" section and couldn't find anything, do you know if they are pre marked for sensors

Alan

I didnt know you wanted instructions to make the holes, it explains how to remove the bumpers.

You could make a mark on the inside of the bumper with something while they are on the car by passing a rod through the holes in the body and then drill them when you take the bumpers off.

Just a suggestion.

 

[andy27168]

Hi,
W202 bumpers were a different pt no. for cars that had PDC so because of that there was no need to mark the positions inside the bumper for fitting the sensors.