Hi
I have an ancient 87 300E and the washer pump has just stopped. I checked the fuses obviously but coulnd't see any blown. Also, the rear section interiour light stays on. Please advise if you can.
thanks in advance
martin in beirut
Hello
Last week my front right lower ball joint started creaking. I found this very useful guide to replacing it:
How-to: Replacing Ball Joints w124 300e - Benzworld.org - Mercedes-Benz Discussion Forum
It says that it doesn't apply to w124s after 1993 because they have the ball joint welded...
Not what some might consider the 'best' colour (although I quite like it) but this looks lovely and at a very reasonable price.
Mercedes 300E (1989) 82000 MILES, 21 MERCEDES SERVICE STAMPS | eBay
Hi MBC folk
i just heard from a mechanic here in Beirut that a 1987 300E doesn;t have a MAF. Is he right? I'm confused as what is that little module which sticks into the wind pipe going into the air filter assembly then?
And do i need to clean the tip of what i believe looks like some kind of...
Seems to be in superb condition, and pretty good price considering.
Mercedes W124 300E Auto 65,000 Miles MBSH Aircon Leather - Immaculate 40+ Pics | eBay
either w124 or w126 i realise coupe sl with the same engine are much to much expensive. a friend really need a whole car does not matter about mot as he need to take out engine gearbox he is on a tight budget.
if u can help and have something suitable if u can take out and fit the engine and...
Hello
My old 300E feels like it needs a bit of a freshen up and I would like to start at the front end -
It was up on a ramp and I was surprised how corroded the springs looked :eek: although the car is really exceptional underneath for the age. The front end has always looked a bit too low...
Hi
Our lovely 300E, which we bought new in 1990, and has only done about 60k miles, has an annoying problem whereby it cuts out at low revs. It'll start again immediately. Our garage has run out of ideas. It's been a recurring problem over the past few years but now is so bad that it's...
Hi all, at last years MOT the garage issued an advisory on my 300E, the advisory reads:
1/ Front (all four inner) suspension arm rubber bush deteriorated but not resulting in excessive movement.
2/ Rear (all) sub-frame rubber bush deteriorated but not resulting in excessive movement.
So my...
Advice please - where to buy etc....
It looks like the centre section has a pretty good hole in it and is blowing quite badly. KwikFit say 185 fitted (!) and I just called an exhaust supplier and they said 125 for the part alone. Not sure how I would get on fitting it myself with axle stands...