hose

I'm hoping someone can help me identify the part number for the radiator overflow hose plastic clip that fits just behind the OSF headlamp. Mine seems to have gone AWOL and the hose just hangs loose without it. You can see it in the pics below, where the hose attaches to the front panel. Thanks :

Hi I'm just about to change my fuel filter however i'm not sure how the hose clips fit or where to get replacements? Do I need a special tool to fit them?

Hello people I'm hoping that someone can help me. Fitting engine back after changing head gasket. There's a vacuum hose coming off the inlet manifold and I can't find where it's supposed to go. Haynes isn't helping so hope someone here will know. This is a W124 2.3l. Have attached a photo and...

Last night I noticed that the hose highlighted in the amber box below appears to be weeping slightly. There appears to be a seam along it's length which is slightly moist, as is the end nearest to the camera. What is it? Easy to replace?

I have an E320 Estate (year 2000) The vent direction activator on my climate control wont move the vent from screen to facia or legs... I suspect that the vacuum hose that drives the system has either holed or corroded and failed. Does anyone have any experience on this and does anyone have a...

Not a Merc, but having fitted a new water pump to the flathead Ford V8 in my Allard, the cooling hose to the radiator base from the pump is now about an inch too short. To fit a new one I need to spec a hose which will fit over a 47mm diameter flanged pipe, which then tapers to 44mm immediately...

Had an advisory on recent MOT about corrosion to one of the rear brake hoses. How much is parts and labour to replace this likely to be?

hi just found the top hose on my c250td flat rather than round,as if the system has a vacuum, car is not losing fluid temp never gets above 80 i changed the expansion cap last week, so is this related ( just put the old one back on)... hose is now back in shape, after taking the expansion cap...

Hi - I wonder has anyone replaced their air intake hose? I have cleaned up my engine bay but the air intake hose spoils the look. I.e, it looks a bit tatty. Are there any aftermarket silcone type hoses that i could use to replace? It it the ribbed hose at the bottom of the stock photo above...

Hi Does anyone know where the vacuum advance hose on the distributor go to/attach. It is the 280 110 engine from an 83 sl. It is attached to the distributor at the mo and is a red hose but does attach to anything, help!! Regards Rich

My BEHR radiator has an anoying weep from the top connector. Having just replaced the head gasket and then the water pump to cure water and oil leaks, I wonder if it is all linked to a change in coolant antifreeze. The connection appears to have a joint in the horizontal plane and I am wary...

How do you use a hose pipe these days? Not had one for many years, but using one would make rinsing the car easier. However modern taps seem to be a completely different shape that you cannot attach a hose pipe to, so how do you do it?

Hi I recently movd to the world of Merc from VAGland.. I bought a uk model 1990 E 300D. Non turbo. Auto. 175k Engine,box,everything very tight until recently!! On driving the changup has become jerky. Was always smooth and refined. Also reverse gear takes 3-4 secs to start moving...

Hi i have a black plastic pipe adrift in my engine bay it is about 4mm OD one end goes to a one inch block on the drivers side inner wing ,does anyone have a diagram of the pipe work to help me out,the car appears to start and run as normal,if i suck on the pipe the throttle linkage across the...

Crankcase - apologies for the poor spelling I have had a hesitation/misfire on my 97 c180 for a few weeks now and have been slowly looking at the problem trying to fix it. its worse when the engine is cold between 1.5 & 2.5 k i replaced the temp sensor and cam magnet and have been watching the...

Hello all, I’m after a bit of help, I’m just about to change the brake fluid in my W123. I have read some of the posts on this site so quite happy to do the job. The thing is I have noticed the main hose that goes to the master cylinder is very age hardened and I would like to replace as...

Tried to take a pic earlier but blinking camera playing up... Basically, C180, its the hos that runs from below the themostat (looks like thermostat housing anyway) to the block. Not the one from the rad/overpressure unit to the thermostat, the one... er... after that. Its quite short. Mine...

Hi A raditator hose has split and I want to get this replaced. Its quite straight forward ( jubliee clips on each end). Only problem is, I don't know the part number/if this is a top or bottom hose. Its hard to explains, but is the thick hose that run from the main block down to the bottom...

i meant to add this to my previous thread, but realised i couldnt change its title, so apologies for two threads. i had oil all over my rocker cover and head, thinking this was an oil leak i thought the rocker cover was at fault. however upon inspection of the inside of the air filter housing...

Hi, just wondered if anyone knows a good new method for sealing a rubber hose end on to a tube, besides the little hose 'O' clips. http://www.wrightsautosupplies.com/page.php?currentpageref=779 about half way down. I need to redo an end on a power steering hose. Usually hydraulic hoses have a...