module

My CLS 320CDI is slow to start, at first I thought it was the cold weather then maybe the battery but after having fault codes scanned its definately the glow plug module. After a bit of research online I know Mercedes changed the module due to issues but does anyone have the Mercedes part...

I'm preparing the car for the MoT, which runs out in three weeks. The SRS warning light stays on after starting for anything from 30 seconds to two minutes or so before it goes out, which may be an MoT failure point. Do others have similar experiences? Also, STAR cannot communicate with the SRS...

I have a boxed Becker nav module for sale that came out of my 2012 W204. Works faultlessly, but may need a software update, I've not done it for over a year. Original red transfer cable included in the box. £200 inc postage to any UK mainland postcode.

Hi all, Retrofitting C43 seats and need to locate a control module for the heated seats from a scrappy and could do with the part number and where it would be hidden on a car ? Regards Brett

Hello ! I've a question in mind ! but before asking it let me explain :D as far as i know; there are two types of EZL modules used on the W201's. The old one that gets the RPM signal from ignition distributor hall sensor & the new one that gets the RPM signal from the flywheel speed sensor...

Hi Guys I was trying to change one of the rear number plate bulbs that didn't work and forgot the lights were still on, subsequently causing a spark and blowing the fuse...at least that's what I thought until I couldn't find the fuse! Some post said they weren't fused but were controlled by...

I am after advice if part number 1248204826 comfort module can be replaced by 1248203226 comfort module.

I have a e320 cdi w211 and it needs a new bcm, can I just get one of eBay or do I need to have it reprogrammed?

Looking to buy one of these on us eBay for $549 , sent them a quick email as in there listing it says cars with air suspension only , they have replied and said they don't fit cars with ABC ?? In there listing it says it fits 230,216 etc which only has ABC ? I'm confused anyone have one on there...

Hi, could any body tell me where is the ABC control module on an S class 221. :wallbash:

As the title says really, I'm after one of these. Anyone got one sitting in the drawer?

Am looking for a good condition Viseeo MD4 to slot into the arm rest socket on a 2009 CLK Thanks Fabes

Just browsing used Mercedes, I've noticed a number of cars appear to have built in sat nav but then have - Satellite Navigation Pre Wire (Optional Maps Module Required) So without the Optional Maps Module, there is no Sat Nav ? Where are these modules obtained from ? What do they cost ? Are...

Hi Chaps I got my new W221 320 CDI a week ago and when I got my car the parktronic worked well, then my battery went flat due to an alternator fault, which has all been resolved, I had to clear out low voltage errors from all the modules with a STAR diagnosis, which I have done, and noticed my...

Can anyone advise me where this is and also advise on removing this

Removed from a late w210, drivers door mirror/window control ecu. Part number 210 820 76 26 £20, located in buckinghamshire.

looks like My selector module has gone awol on the CLK 430 i had had trouble couple of years ago if car stood in cold/winter for a while it would not display gear and limit itself to 1st & 2nd until restarted from warm . However for the past 12mths its been fine no problems at all , but...

Hi everyone, is it possible to repair the Clock Display Module No. A0015420314,the clock works ok but it does not light up and is unreadable. Many Thanks for your help. Graham

Hi guys, would any of you fine gentlemen know if a TCM " A030 545 4032 out of early 2003 E240 can it be replaced by a TCM from exactly same car but 1 year later model with a different TCM # a 0325452432 using a Star & readapting to transmission. Regards Barry :confused:

Hi all! I had a few questions about the lowering module i am hoping someone can answer. I have just had the module fitted on my SL55 and wanted to know the following, as the instructions aren't very detailed at all... 1) When I set each individual suspension the same value, say for example...