Contrary to popular belief the DRL surrounds can be removed without removing the bumper.
I wanted to replace the plasti dip with a carbon wrap so here's how I did it.
Firstly put painters tape around the drl cover to avoid scratching the paint on the bumper.
The surround itself has 4...
Hi all,
Decided I'd have a look at my parking sensors on my ML320 to see if there were any obvious loose wires or moisture ingress issues (intermittent fault) which required removing the front bumper of the car.
I got the work instruction AR88.20-P-2000GZ which I followed through (took me...
Hi Guys
Need help please. Am thinking of fitting DRLs next to the front fog lights (Insurance company likes this). The fog lights are recessed behind the plastic cross hatched mesh insert in the lower left/right of the front bumper. The insert also holds the bright-work surrounding each fog...
As above-
One of the gotchas on a E300 I bought.
It's not a suction mount as the seller claimed but is glued....to a leather dash. Any wisdom about how I remove it without leaving a scar - of even whether I can remove it without leaving a scar.
Google suggests veg oil in a dam to contain the...
I've installed turbochargers easier than it has been to install a carbon diffuser to my coupe. What's the deal, is there a guide for the coupe/facelift saloon?
The pre-facelift saloon was much easier with two torx, one per side next to the exhaust tips and a couple of brackets more centrally...
I want to remove all of these horrible systems that Mercedes have fitted to me car, EGR valve, Inlet port flaps etc, after cleaning my EGR valve last month it actually upsets me to see how much crap is going through my engine.
Have I read correctly that the software for these systems can't be...
Can't tell you how good it feels. It was one of those annoying ones you see every day when you go to the car.
Feel like I've accomplished something today!
Hi Everyone,
I´ve finally found a reasonably priced command head unit for my W211, and wondered if someone could point me in the direction of a guide on how to remove and replace? I understand it is relatively straightforward.
I remember there was one, but I can´t find it anywhere...
Hi all
I can't believe this is being such a problem must be a senior moment.
I need to get to the handbrake mech under the back seat because it is sticking and the warning light stays on I had a tip on the forum too lift the pedal with the foot as you release it and it works but it is obviously...
Hi guys, I have managed to get hold of a Co-Trim bulkhead for my 2009 Dualiner so that I can convert my van. I have managed to removed the pillar trims and roof lining but am struggling to remove the large side loadspace trims. I want to remove them without destroying them but can't work out...
Hi All,
I'm going to tackle replacing the seals in my Brake Master Cylinder today. As I've got that out and need to bleed the brakes anyway, I'm going to remove the ABS pump to clear a blocked drain hole and give it a good clean.
Do I need to do anything special or is it just a case of...
Hi, I want to remove and adjust the fixings for my r129's front bumper. Its the AMG kit and was wondering if there are any guides to do this? Can this be a one man job on the driveway or more advanced?
Like it says, there is no power at all in the car (or doors for that matter !) need to get the seats forwards to get to the rear bolts. Is there a clutch mechanism on the seats that you can disengage the motors to pull the seat forwards or does anyone know what wires in the loom by the seat...
Are there any issues with removing the car phone that I have installed in my clk w208? I have the handset in the armrest and some kind of receiver/transmitter in the glove box. Can I just cut the wires and remove them?
Sorry if that's a really daft question!
hi
my silver W124 estate has some corrosion around the inner window frame where the rubber goes for the rear side windows.
i want to remove the windows and repair the rust and reseal the windows, before the rust gets through to the outer bodywork requiring paint etc
how do you remove the trim...
The previous owner swapped my front foglights with Xenons :ban: - Yes I know :D but actually they are extremely useful at night as the 'follow me home' lighting lights up my garage brilliantly. as they are brighter than the sun!
Twice they have both stopped working, after removing the wheel...
Hi all,
I've watched loads of videos of people who have removed secondary cats and or resonators. To me, personally, a lot sound really raspy and un-refined, more like a shouting car rather than a deep rumbling puuurrrrr like the original C63 sound.
I just watched this video, I think, going...
Hi Everybody,
My butter fingers just scratched the ashtray cover on my new Merc w205 2014 c class. I ordered a replacement from MB. However, no body in the local MB dealer knows how to remove the ashtray cover on these new cars.
Does any body know how to remove the ashtray cover and...