seal

Dear All, If I am going to have the heads off my engine, for the purpose of replacing the valve guides, etc. could I ask for opinion on the following please? 1. Are there any other works I should have done at the same time? 2. How much should I expect to pay? 3. Can anyone recommend somewhere...

Hi Can anyone tell me how to replace the rubber seal around the steering wheel columb that separates the passenger compartment from the engine compartment??

Hello, I blew an injector seal on my w414 1.7cdi Vaneo the other day. Every 4th stroke the engine goes Phhhew. So I dropped the tub into the local garage soonest and they confirmed. Now, they have ordered seals, and they ordered a new injector (as I know I have a historical problem with #3...

Grateful for any advice on replacing the door weather strips (rubber seal between window and top of door skin) - the ones on my C43 no longer seal and I can't clear the window by winding it down...! Thanks in advance, Mike

hi garage told me last week after mot drive shaft seal is leaking and i should look at getting it fixed should i cancel christmas this year or is this a straightforward and not too expensive repair? it is for a 96 r129 cheers

I own a 1991 Mercedes 190E 2.3. The front passenger door seal doesnt seem to be flushed against the door as well as the front driver door. There is a small gap between the thin lip and the frame of the car. The driver's side is perfectly flushed against the door; no gap. We had an...

The rubber seal round the base of the antenna has started to break up, as the UV rays has made it go brittle :( Spoke to my local dealer and it's only available with the antenna cap (item 115 HERE ) at a cost of about £38 :crazy: because they apparently bond the seal to the cap :dk::doh...

Can anyone with EPC tell me the P/N please for the drivers door seal, the one attached to the door itself held on by plastic strips with clips? Also does the seal come with new clips? TIA

Hello, My W126 Sunroof seal is very dry and has come loose in one corner and it also stops the roof from the tilt position. Is there a sealant to fix the rubber back in place and what can I use to clean it. Is it cheaper to get a new seal, my current one is pretty dry but its not got to...

Lisas car has a small oil leak that i initially thought was the rocker gaskets but after replacing the cps the other day the rockers seem pretty dry but the cps when removed was soaked in engine oil. So assuming the rear seal has gone? has anyone else come across this on the 112 engine...

Guys, How hard is it to change the Bridge seal on a S280 24V. Need new rad so while I have rad off and fluids drained gonna fit new crank seal and bridge seal. Only drops 1 LTR between 12mth service, 6000mls. Any advise will be great. Richard

hi all, my rear quarter light lower window trim has been stolen! strange thing to steal but there you are. i ordered the new trim from mb and it doesnt come with the clips to secure it back to the bodywork and mb dont list them as a spare. they suspect they must come with the glass...

Just got mine back this morning after it had been dripping oil all over the driveway. Problem was identified as needing a new 'Turbo Seal'. Can anyone tell me what this is - tbh, didn't even think my car had a turbo! I realise I should have asked the guy at the MB garage, but was in a...

Hi I need to replace the rubber seal on the rear side window of my 2002 230 kompressor cabriolet. I picked up the new seal from MB Parts but nobody could give me the correct way to fix it nor did the seal come with any fixings and apparently none were listed. The old one appears to have a...

I have a 1998 W208 clk230 convertible and the seal on the rear window (effectively the B pillar seal) is torn - this is the seal that runs down the front of the drivers side rear window which the drivers door glass seals against. Not a major problem but I'd like to sort it out. I have searched...

Hi, Ive got a 3yr old SLK with a tiny dripping water issue on the drivers side window. On closer inspection the seal is being pinched when the window rolls up the 10mm automatically when the door is shut. The seal gets caught right at the join of the roof to the windsreen pillar and is pushed...

im just doing a quick check with club before i purchase a bottle of k-seal has anyone on the forum ever used this im going to use it as a precaution before the head gasket goes as i know my car w202 95 is prone to head gasket failure anyone have any info on this for me

I have a 1987 300D which is auto and has the OM603 engine. The rear crank seal is starting to go as I have noticed a few drops of oil on the garage floor and it is engine oil coming from between the engine and gearbox. How long should I leave this as there is not a lot of oil, but it can only...

I know there are one or two people about to replace their delivery valve seals on their OM606 engines. I would like to sound a note of caution - this is a job that can easily go wrong. The latest to be caught out, albeit with a 603, is here...

Does anyone know of a decent product that keeps the rubber seals in good condition. My front rubber on the toprail of my widscreen is looking tired (5yrs old R230) and I use Autoglym, but at a recent visit to my MB dealer they put on a far thicker conditioner which has worked well. It can be...