Can someone please tell me the location of the lambda sensor? Is it easy to get to it? Do I need ramp and am I right that there is only one lambda sensor in my car?
A quick question related to my '94 SL500, if I may. Am I right in thinking that the total working electrical part of the MAF sensor can be removed simply by unscrewing the two screws?
I ask because the wire mesh in the top of my MAF is past its best, but I have an almost new, but faulty...
Suddenly the front drivers side is showing proximity all the time. It varies from 1 to 4 yellow lights. They seem to work, in that if i get closer more come on and the passenger side and rear are fine. I've given them a clean but n/c.
Should i suspect a damaged wire?
Error message on dash esp/abs defective
This code came up after a scan and clearing the codes this code came up again:
C1479 check component L6/3 (left rear speed sensor)
So question is do I just change the sensor and that will cure the problem or could it be something more.
New...
Hi,
The sensor has stopped working I'm getting the lane assist assist and blind spot inoperative in he display. Anybody changed one and is it difficult?
Thanks
Probably been asked before but can someone help out and tell me the location of the crankshaft sensor my eml came on earlier and mentioned crankshaft sensor on a basic diag box.
Also is it just a easy unbolt remove and refit affair
Thanks all
Hi guys,
AC not worked for while in my Vito W639 120cdi, suddenly stopped blowing cold & compressor does not turn on, checked fault codes, not sure what 2nd code means but 1st says faulty Refrigerant Pressure Sensor.
Shall I replace the sensor or could this code have been triggered...
Gents,
My temp gauge is showing a consistently low temperature (40-50C). So I plan on replacing both the thermostat and temp sensor.
Could someone please confirm where the sensor is located. I've done a few searches on-line but never seem to find one for my engine.
Cheers Dale
Oops obviously...
Hello all my car performance took a major dip when the weather
Got cold I did the £12 hose replacement mine was complete gone. My mpg drop to around town 20/25 but on run get 38, so I decided to
Disconnected mag sensor recently and
My mpg has got much better engine light is now on,
Can I get...
Hi,
recently I started receiving inaccurate outside temperature readings.
After checking
I discovered it cracked on the tip. It need to be replaced.
I have found some spare parts on eBay but not sure if correct.
Could anybody tell me the correct MB part number please?
Kind regards
Hi, have a 2008 CLS 500, I had a creak from the front left suspension and started doing the ball joint, got it apart and it was fine, then realised that the noise was coming from the Airmatic level sensor when I detached the dog bone that connects it to the top wishbone.
I doused it in WD40...
Hey guys,will be replacing the fuel filter on my W204 C220 cdi, do you guys just change the filter and transfer over the integrated heating sensor from your old filter. Or is it best just to buy the filter with a new sensor already attached?
Hi guys
My outside temperature sensor is occasionally reading the wrong temperature. I have seen online (eBay) there is a temperature sensor that goes in the lower grill. But when I look on places like EuroCarParts and GSF they don't list such a thing.
Is this what reads the outside temp...
Been getting an endless problem for about 18 months with the management light coming on and indicating P0101 and maf sensor problems
I've changed that several times firstly with pattern ones and finally with a genuine one. Still the light comes on.
Also changed the map sensor, the cam position...
Hiya
Like most, I work and do not have time to leave my car with MB or the hassle of going there.
Bought the car brand new in April MB GLE, AMG-line - I'm the only driver, covered about 4k miles, no accidents (keyed a couple of months ago) or contact with garage door/wall etc.
Noted an...
Hi just going to fit this new temperature sensor.I need to know how to connect the leads on the end .Looking at the sensor ,,and the connector you can fit them on two ways .Nothing to stop you doing so .Is this right ?
Where is this on a w211 and any idea of cost.
Code coming up is
Check component b5/1, the signal voltage is too high. This code was shown on a scan over 12 months ago. Since then intermittently it goes into limp mode (rarely)
Since yesterday on start up the car revs all the way to red but...
Hi guys, got a few issues & not sure if their related, bare with me I'll try explain :thumb:
Had my Vito auto 2009 120cdi 3yrs and been great but occasionally has gone into limp mode but after a restart all is usually fine, however today engine management light came on after restart and...
I have a 2001 W203 RHD. The Yaw rate sensor (turn rate sensor) has been diagnosed as faulty. I have been told that this sensor is underneath the centre console. If this is correct does anyone know where precisely this part is located.