uneven

had a VHC done at MB today and their video showed uneven tyre wear front and back. Both fronts were wearing on the inside and outside section, by 3mm compared to the middle. They are pirelli p zero's 245/35/19's with 38psi The rears are 1.5mm less on the inside edge compared with the...

I have a late 2010 w221, the right side (front and back) suspension is about an inch lower than the left hand side. Goes up and down fine. Any ideas ?

Not huge, but noticeable nonetheless - about 2mm difference between the left and right hand sides: I looked at glovebox removal WIS page - AR68.10-P-1400AK - but there's nothing about adjusting the hinges, which I presume, and hope, is possible? Adjusting the little rubber buffers on...

First, thanks to all for the years of support this forum has given me without even having to create a post!!! This time a post may be needed!!! I have a problem with my Mercedes Benz. When I drive for period of time, say 30 minutes, any point I have to come to a stop there is a high...

Yesterday I took my 2012 C63 PPP to have its tyres checked and then its MOT. Kwik Fit told me "Your tyres are good for another 1500 miles", which was a pleasant surprise. The MOT results was "Failed due to tyres being down to the canvass" an unpleasant surprise. I was frankly...

Hi all just need to of anybody who has experienced this , I used to run 255/30/19 tyres on rear axle but moved a notch up to 265/30/19 , not a great difference as the tyre still looks like it's the same size but Iv noticed on the rear tyres are starting to go on the inner sides of both, I don't...

Hi everyone, Just wanted to pick your brains on this one..I purchased a w140 s320 limo business edition in august. Great car, which I purchased from a relative. As the owner has passed away, the car was parked up for about 9 months. When I got the car the engine was running rich, black...

Hi Any help over knocking problem can't locate it, When going over bumps in the road at speeds of less than 40 i get a metallic knock/ rattle from the front corner of the car. Ive had the roll bar bushes changed , idle bush linkage and engine mounts changed, still no change. i removed the front...

I'm getting very uneven wear on all four tyres. I had four wheel alignment carried out and that looks fine although I'm going to repeat this. Everything else seems ok. The inner edges are wearing a lot quicker than they should though. I put aftermarket wheels on. 8 and 9 inch staggered...

Car is a 2010 E350 CDI owned from new (so I know it's history). I noticed recently that my front N/S tyre is wearing smooth on the outer edge. The front O/S tye is also wearing smooth on the outer edge it is nowhere near as far gone. The car has done 42k and these tyres probably about 12-15k...

The inner of my front right tyre is wearing unevenly and causing some rumbling noises. I've done about 7k miles on them, have about 3mm left (on the outside) and they are 19" Conti 5P MO tyres. I've seen loads of threads on this and recommendations for 4 wheel alignment adding bolts and...

My S320 has just had an MOT and passed ok except I can hear this knocking/ tapping type noise when travelling on slightly bumpy surfaces. I don't know much about the car yet as I've only just purchased it. I'm thinking it could be a fractured shock absorber as had a similar issue with my C200...

Hi, I have just had the rear coil springs replaced because the 'drivers side' had snapped. However, there is still approx 10mm difference on the drivers side verse the passenger side. Both new springs are OEM so are the front springs which were replaced 5wks earlier. I believe the rear springs...

Hi, my W210 e320 (m112) has an uneven idle which is more noticable in neutral than in 'D' with your foot on the brake but still noticable in the latter. It's sometimes not present if the engine is hot & been for a decent run but more often than not the fault is there. I went to change the...

hi guys. my 2001 220 cdi seems to be a bit rough on the idle.not all the time but some times to the point of almost missing. i have today checked the engine mounts all ok. i have noticed that the rear exhaust mount by the rear wheels has snapped. doubt if it is related. any ideas please...

Hello all, I’ve noticed that my car has started to wear the outside edge of the nearside front tyre. Tyre pressures are all ok and there no noticeable vibrations through the steering wheel and the car is isn’t pulling to one side The car has always worn the outside edge of this tyre a...

Hi,on checking my rear tyres i noticed they are both wearing more on the outside(the 1st 3 inches closest to the alloys)they are 285/30 pirelli p-zeros on 19's,they had 7mm on them 6,000 miles ago when i bought the car(cls500) last october & i knew the rears from new are only good for about...

Hi, my first post here. I have a Vito 111 CDI that was purchased new about 2 years ago. At about 10000 miles I need to replace the front tyres due to uneven tyre wear. I took it to a dealer and had the alignment/geometry checked. This was done with the van loaded as I normally drive it. They...

Hi all I was wondering whther you might be able to shed some light on this please. 93L W124 E220. The car has an annoying intermittent fault of the idle fluctuating mostly when the car is warm. Doesn't happen all the time, but when it does it nearly stalls cos the revs drop so low. Any idea...

Hi, My 09 W211 280CDI Avantgarde has covered circa 18k miles and needs new rear tyres. However, the tyre wear on both tyres is very uneven. The inside / middle of the tyre is on the limit, but the outside edge still has lots of life (both sides appear to be wearing in exactly the same way)...