cmarkod
Active Member
Sometimes when I brake I get a virbation through the brake pedal accompanied by a buzzing sound. This lasts for a few seconds and then stops. It sometimes carries on for a short time after I've released the pedal. Any ideas??
Vibration through brake pedal when braking
Dieselman
Banned
- Joined
- Jul 13, 2003
- Messages
- 34,199
- Car
- Peugeot 403 Convertible
SBC unit recharging.
I'd get that checked as it sounds like the SBC system is losing residual pressure.
I'd get that checked as it sounds like the SBC system is losing residual pressure.
cmarkod
Active Member
Thanks. Will do.
Individual one
Active Member
- Joined
- Feb 17, 2008
- Messages
- 66
- Location
- South Yorkshire
- Car
- CLK 230 Convertible/BMW E46 M3 Convertible
Hi, i dont know the mileage, but that's one indication of warped disc's.
- Joined
- Feb 8, 2007
- Messages
- 20,694
- Location
- Portsmouth, Hampshire.
- Car
- E55K SL500 E250X2 Smart44 Brabus Track car E450Cabriolet X350 Pick up
It may need a software update. Your dealer can tell you.
cmarkod
Active Member
vibration sound from the car. It is intermittent and can carry on for a few seconds after the brakes have been applied. No warning sounds or lights from the dash.
Satch
MB Enthusiast
- Joined
- Nov 24, 2003
- Messages
- 3,508
- Location
- Surrey
- Car
- S211 E320Cdi Avantgarde Estate & Toyota Land Cruiser
Assuming your car is fitted with SBC braking system sounds very much like normal operation of an SBC pump to me.
It is a sort of "Bggggggggrrrrrrrrrrrrrrrrrrrrrr" sound and in general you only tend to notice it when car is stationary or at low speed.
There were a number of recalls on the SBC system and IIRC if they are all done you should have an additional aluminium bracket attaching the cable connector to unit, a blob of white paint on the pump body and a red "do not remove....." label on the wiring.
If in doubt ask dealer to check if all SBC recalls (if required because it depends on age of car and the serial number of SBC pump) have been done.
It is a sort of "Bggggggggrrrrrrrrrrrrrrrrrrrrrr" sound and in general you only tend to notice it when car is stationary or at low speed.
There were a number of recalls on the SBC system and IIRC if they are all done you should have an additional aluminium bracket attaching the cable connector to unit, a blob of white paint on the pump body and a red "do not remove....." label on the wiring.
If in doubt ask dealer to check if all SBC recalls (if required because it depends on age of car and the serial number of SBC pump) have been done.
