W208 clk200 rough idle when cold

Discussion in 'Engine' started by 666bxg, May 19, 2007.

  1. 666bxg

    666bxg Active Member

    Messages:
    64
    Joined:
    Feb 7, 2004
    hi

    i recently had my ECU replaced with a used one after it blew. everything was going on fine until about 1 month after the ECU was fitted

    from cold starts i'm getting a rough idle, and occassionally would stall once D is selected. if left for a few mins everything will be fine. alternatively if i switched the engine off and on again, the problem is solved

    could anyone help point me in the right direction? MAF? O2 sensor?

    thanks in advance
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.