pipe

Help plz. Does a crankcase breather pipe cause engine to idle rough

My engine runs rough on tick over fine top end just wondering does the crankcase breather pipe if broke cause rough idle plz help thankyou.

my car has just started ticking over like its hunting its ok when driving but when idling its rough any ideas would be great ?

I am hitting a wall on the hunt of a power steering hose and pressure pipe for my SL. Its the one connected to the bottom of the radiator, the hose mounting has rusted and taken the steel pipe with it. Has anyone any idea of the part number ???. Regards in advance.

Hi everyone, I have a Mercedes C250 2.2 Turbo Diesel I was wondering If I was to get a Straight Pipe done too it i.e. Removing Muffler and Silencer. Will it harm the turbo or engine by doing this? Would appreciate if anyone can help me out thanks.

Hi all, any advice on fitting an exhaust bypass pipe similar to the image: it's a basic y pipe that fits inline with the standard exhaust system with the leg venting to atmosphere. If it's too loud or not to liking the leg and be blanked off or replace the whole pipe with a straight to go back...

Buyer to Collect else it goes down the tip...

One of my brake pipes is leaking and I need to either replace the failed section with copper pipe or replace the whole lenght from the rear to the front of the car, however to replace the whole pipe will require dropping the fule tank as the original route takes all the brake and fuel pipes...

Selling: Front pipe for exhaust system MERCEDES BENZ R107 AND C107 280SL and 280SLC RHD (Right Hand Drive) Original part, "new from old stock" Very heavy original quality, labelled with original MB labels. Does not fit other models. For motorcars without catalytic convertor / catalyst...

Hi all i have my old CKS x pipe for sale. It was fitted to a w211 E55 and i believe it would also fit a CLS55 and perhaps other platforms but please check first. It has served me well till i have gone passed a certain point of tuning with my car. Looking for £250 but open to any...

52 w211 e320cdi i am going to fit a 13 row cooler for the gearbox & also an inline 80degree thermostat but before ordering need to know what size the original cooler pipes are. Does anyone know?? thanks James

I am trying to remove the air filter box on my c180k but the vacuum line above the MAF will not budge. Is it as simple as it looks? Just squeeze the circular clip and pull but there is no movement and I am very reluctant to resort to brute force and ignorance just yet. Thanking you for any...

Can anyone help me please? I need the part number of the ABC pipe going from the rear drivers side strut to the rear valve block. (its for a 2001 CL55AMG) Thanks!!

Hi All, My headlight levelling switch is not working on my 05 C180-S203 which is a bit worrying on these dark mornings. I suspect its something to do with the vacuum pipes so I've had a good delve round the engine bay and the two purple pipes are connected to the headlamp cluster okay but then...

My 300TE passed it's MoT today, which I'm very pleased about, but while it was on the ramp the tester showed me that the hard breather line from the fuel tank to the filler was very rusty. (Annoyingly this was an advisory on the old MoT and the vendor told me he had sorted it.) The thing...

I being quoted just shy of £2000 to have part hydraulic pipe 2203205672 as stated it has bursting my 2000 Plate CL600. Independent Mercedes Specialist SPR Autos - Stockport. Please see attached. REMOVE ANGINE AND GEAR BOX TO FIT ABC CONTOL PIPE - 20 hours x £55 = £1100 2203205672 LINE - 1x £495...

I have tried to Google the part number for the 'Y' pipe (air inlet) that is fitted to the OM 642 V6 diesel engine in my car. (and turned-up a blank) It has been over-tightened by someone in the past,and the plastic has cracked, and therefore oil can leak from it directly onto the inlet port...

Hi can anyone tell me the name of this pipe, it runs from the rail by injectors around to back of engine by drive belt? Any help appreciated

Hi all, Noticed a bit of a diesel smell in the engine bay, and traced it to a connection which was weeping a bit, when I tried to push it together to see if it was just loose, the connection split. :fail Can anyone tell me if it is possible to just get a new connector, or is the hose supplied...

Hi forum members, I have a vito MK1 van (638) I would like to fit a chrome tail pipe, after I cut the slight bend that is on the end off. Does any one know the exhaust o/s diamater, am I right in saying about 60mm ? Thanks, Roy.