Anywhere online I can order these from? Have had a look on ebay but they all seem to be for the 300D.
Also I have read that Bosch quality of the nozzles is not what it used to be, is this true?
So I'm looking to my friends 2009 C220 CdI auto 110k on the clock for a mates rate quite below the current sale price on the market.
I've read into the injectors and it has the Delphi + solenoid with the black pipes
There is some residue which is dry and not fresh oil closely around this area...
Hello All.
I would appreciate some help.
I few weeks ago - I replaced injector number 5 copper seal because it was blowing gases and partial combustion tar. Before this - the vehicle started every time, even it is was a longer crank than originally known.
To remove the injector, I used a...
Hi everyone
New here so 1st post.
Would like some opinions to my dilemma. I have a 2008 c200 cdi
Only bought it last week and car had started to misbehave.
Once i start the car the accelerator is dead and car idles at 1100rpm
When i clear faults car returns to normal and faults stay...
Hi all, I have 110 CDI 1999 Vito, I bought the van 2 years back, 98,000k, 2 owners from new, it was a horrible green van but very little rust, so I have stripped it done a full interior and exterior color change to grey, now my problem is when i started this project, the van run fine, it was...
Hello again everyone
Can anyone tell me what the differences are in the injectors in the 108cdi range. I have been told that there are 3 different injectors for the 108 and they changed throughout the series.
I am still playing with my 2000 vito and have it to the point where now I can...
At long last managed to get all 4 injectors out using the screw-in puller, which entailed dismantling the injector tops before removing. I think the rocker cover's OK, but the problem I've got is that I have lost two of the tiny steel balls from inside the injectors.
I'm going to need to get...
hello.
2nd forum post ever. i'm new to all this.
Since buying E20cdi estate in Sept 15 at 101k, my left bank injectors have failed twice.
1 week after purchase, smell of deisel led back to MB indy nr Leicester and injector seal fixed. On colder days, the car was/is rough to start and noisy...
Hi, I'm new to the forum and realise I'm raising a much discussed topic, apologies if I'm covering old ground.
I have a 2002 ML270 with 150k miles. It's had 3 of its 5 injectors removed within the last 3-4 years and I believe the retaining bolt holes for a couple of them were helicoiled or...
I've bought a set of s/h injectors which I'm going to get rebuilt with new nozzles. The nozzle options seem to be:
Bosch - off the shelf but I've heard the current Indian made nozzles are poor quality, are they really that bad? It would be a bummer to splash out £120 on the nozzles, same...
Hi, i have had the issue of struggling to start at most times so checked the clear plastic pipes(all new last year) and swapped the rubber washers for new green MB ones - no help.
So i've just done a quick leak off test with the plastic bottles and found inj no4 (nearest the bulkhead)...
Hi guys, new to the forum so be kind.
My trust C220 is making me lose what little hair I have. Long story here goes :
I have had a leaky injector for a while, last week I removed it and replaced the seal, all good, no leaks off I went. Tuesday this week was out and about and noticed the...
Hi,
Please can someone tell me if it is ever appropriate to use releasing fluid and the engines own compression to release seized injectors and if not, what can go wrong? Thanks (mercedes e320 cdi avantgarde)
I want to remove the injectors from my OM642 engine. What is the best puller for the job? The slide hammer type or the screw over collar type?
Mercedes Injector Puller Extractor Remover Diesel CDI Engines C E Class Sprinter | eBay
Diesel Injector Puller Set Injectors Extractor Special...
Just thought I would throw this one out there and see if anyone else has had any Injector issues.
Basically over the last few months I have had 2 x fuel injectors fail on my C63 (5 year old with 29K on the clock running a Stage 2 Weistec Supercharger for the last 11K miles)
The first failure...
Hi all, just discovered the injector leak while i was adding windscreen fluid, i could see a small oil like stain on the plastic engine cover, so i took it off, only to discover the first injector leaking....oooh the joys of life!!!!
With the cover off i could smell the gases, but not from...
Hi all,
bought a new seat cutting tool for my I6 320cdi as 2 of my injectors are leaking again, and I am just looking to confirm which reamer to use, the box states it is 17 x 17mm angled reamer for the CDI is this correct?
hi all, 2 of my 4 injectors were leaking and got them replaced from my local garage and now alot of black smoke from back, could you please give me an idea of what could be the problem. car was running perfect before this injector issue.
no errors/codes on computer, and he cleaned all pipes and...
Hi Guys,
My ML makes an annoying Ticking/Chuffing noise only when warm and only under load, I've removed the air boxes, checked the injectors and I can see no evidence of a leaking injector?
I also cannot see any evidence of a cracked or leaking exhaust manifold..
Are there any other...
Hi All,
My 2006 ML W164 has a leaky injector, I lifted off the engine cover and with it running it puffs from that injector and I can smell the gases, there is also alot of gunk around said injector...
Not really a major isssue just change the seal but I am off on Holiday Saturday with a...