hello,
new to this forum and looking some advice please.
ive a 2005 e320cdi with around 110k.
its starting fine however now once the glow plug light goes off after starting the car it comes back on again for a couple of minutes before going off.
its due a serive soon and the guy who works on it...
Whilst lying here with the lurgy, I was contemplating the upcoming changing of the glow plug relay. I've realised I don't know where it is, so I thought the forum might like to enlighten me, as inevitably I going to end up doing it in the dark and rain with a slightly dodgy torch and a...
Good day all. My. 1999 c240 is fitted with 2. 2 kilo ohm plug wires. But the dealer supplies 3. 3 kilo ohm units as replacements . I find a markable reduction in performance with them fitted. What are you recommendations, will doing a CPU reset help.... I have gone back to the old plug...
The glowplug light on my 2007 E320CDi has come on.
The light comes on as normal, goes off and then I start the engine. Immediately the light comes back on and stays on for about a minute.
It started behaving like this for a week or so, then it cleared itself and behaved normally for a...
Hi,
My problem is on a W211 320cdi V6 (2008) for which I don't find a solution in the existing treats.
In the morning, the car will not start immediately, but when you preheat 3 or 4 times before starting, it starts without any problem.
Because the glow plug controller is a common...
My glow plug light sometimes comes on at wrong time.
Can travel miles from engine cold to normal running temp with no problem.
If I stop for 10 mins or so when I re start and run short distance the glow plug light comes for a time while running then goes out but may come back on.
Any ideas I...
Hello everyone
I bought a 025 545 28 32 glowplug relay
It is a vito (4cyl)
I bought it because I have broken 2 glow plugs in my 5-cyl machine (E270 W211). I know, the relay is built up like that.
Pin 1 cyl 1
Pin 2 cyl 2
I want only preheat cyl 3.4.5 not cyl 1.2(glow plug is broken)
How...
Apologies if this is a dumb question(have to ask though) i want to change/inspect the plugs but don't have the tool, are these universal ?
I have a 280CE 1977 Coupe.
Thanks
David
Folks
Free to a good home. A full set of plug lead number flags. If you like engine detailing then these are really neat things to have. These fit over the lead and do not clip around the lead. Let me know please.
I just broke the last glow plug I had to remove. It was the last one right up against the bulkhead in an awkward place. I need a recommendation of someone who can come out and remove it. I've just had a quote of £270 which I think is ludicrous especially just for one glow plug.
Thanks
Starting car this morning, key in, ignition on, wait for glow plug light to go off, turn key to start.Engine starts but glow plug light then comes back on again for 15-20 seconds then goes off.
Stopped for fuel restarted all normal.
Just been out again and glow plug light again came back on...
My glow plug light stays on after the engine is started. It can also be difficult to start at times. If i give it 3 glows is usually starts quickly. I got a diagnostic done and was informed of 2 faulty plugs. Should i replace the 2 plugs or replace them all? Is is easy to do on the v6 as a diy...
started car in the morning from work Tuesday morning so wasn't cold glow plug light come on then went off, started car and did take awhile to start 3/4 seconds glow plug light still on :( turned car off then on again and glow plug light went out but as I was driving light flashed approx every...
Hi guys some help or advice please. The glow plug light was staying on after starting car so I took it into garage and had all the plugs replaced . Now the light stays on after the first start only it goes out normally on second restart and stays off. Any ideas please thanks
Finally got round to changing my glow plugs.
Took them out and found MB use the BERU. Bought the Hidria version from ECP.
Used a torque spanner and a 10mm deep socket. All was fairly easy thanks to MBCLUB.
Tools used.
The 2nd was harder cos of the wire and fuel line. I removed just the...
Hi,
1st post :)
New to this site and would appreciate some help.
I have a 2010 B180 cdi, and I'm attempting to carry out an engine oil and filter change. I've managed to locate the filter, but struggling to find the sump plug. I've removed the weather covers and can't seem to see...