• The Forums are now open to new registrations, adverts are also being de-tuned.

point

  1. M.A.94

    Trolly jack + long bolt in jacking point

    I've seen a few people do this now. Putting a long bolt in the slot for the spare wheel jack and then using a trolly jack to lift the car from the bolt. (See image below) I can kind of see this working as the jacking point where the bolt is placed is where the emergency boot jack would...
  2. mercmancdi

    Anyone point me to thread on remap E200.

    Anyone get a remap on E200 w212 , or anyone know anywhere in n.ireland can do it with rolling rd or at least proven to do good job etc , any recomendations welcolme . Thanks hope this posted is in right place .sorry if not.
  3. F

    plastic cover for jacking point

    any idea where I can get a replacement part...cheers
  4. clk320x

    W209 Xenon Earth Point

    Can anybody confirm the earthing points for W209s for the Xenon lights? As of previous threads mine fail to start sometimes and need restarting before working perfectly Will check earth before replacing bulbs or SAM? As both sides are affected not sure if last owner put in cheap bulbs, as...
  5. demetrios

    Alternative charging point?

    Hi guys, Merc has locked me out again, can gain access to interior with key unlock on passenger side but drivers door and boot won't unlock and battery is dead! Last time this happened a while back managed to get the Sparks onto somewhere in engine bay which gave enough juice for remote to...
  6. MikeInWimbledon

    Night vision - is there any point?

    Bemused by the Night Vision feature on my W221. I can't see the point of it. It doesn't give me anything better than my eyes can see. Am I missing something?
  7. J

    W208 cant get in boot. Not even with charging point powered

    Hi All, Im hoping someone can help point me in the right direction with the boot that wont release on my X plate W208 clk 430 cab. Ive been a bit of an idiot. Ive had a dodgy battery for a few months (I dont drive it very often and no power in the garage to trickle charge it). Ive had to...
  8. Drewpy

    W245 rear cenre jacking point

    Evening all, Just want to pick your brains regarding the rear centre Jacking point on the B class. I can see where it goes, but is it inbetween the plastic shroud or do I rest the jack (with protection) on the front of the shroud where the surface changes to a non slip area? do i need an...
  9. A

    Any point in shopping around for parts?

    In the past, I've rung MB in Beaconsfield for quotes. Is it the same cost for MB parts in every dealership or can they offer individual deals? If the latter, where tends to be good? Alternatively, are there any good parts companies left on these boards? I've tried and failed in the past...
  10. A

    Meeting point of value for CLS55 vs. CLS63?

    As some of you may be aware, I've had my eye out for a CLS55 and have seen fair prices of around £11k for 90-100k miles up to about £15k for 60k miles (good examples with reasonable extras in the right colours). Mostly the prices above that seem to be indy dealers taking the pee. Under that...
  11. T

    CLS Axle Stand Point

    Silly question time, I had a look under a CLS today, I could see each of the 4 jacking points, I think I'd get a jack pad to lift it up. But it was not obvious where the axel stand points were? Does anyone have any photos or description of where I put axel stands, on a W219?
  12. RichardF

    Rear lap belt wanted R129 or swap 3 point harness

    Hi I'm after a rear lapbelt for an R129 SL in black if anyone has one? I've a 3 point harness in the back on the passenger side (works with child seats) that I'm happy to swap. It looks genuine MB, the fittings match and it uses the original socket.
  13. Headhurts

    Leather - is there any point?

    Given that most of what I read says my cars have been leather coated with a vinyl or similar product is there any point of applying leather care treatments? I have several in the garage and have been using them. My current car is an E350 Night Edition with leather seats, as this car is not...
  14. Y

    Clc ground point on passenger sidr chassis leg

    Hi all, My ground wires on the passenger side chassis leg are ripped off, i believe one goes to the foglight anyone know where the others should go as i can not see where they have been pulled off Cheers
  15. L

    What's the point ?

    So I've been on Autotrader, Gumtree, ebay etc looking for a little project car, I'm not really sure what I want, everything from a MKI XR2 to an early TT, really can't decide. Anyway as usual my mind wandered and I started looking at 205 C63 prices, my excitement level jumped when I seen a...
  16. Pathewolf

    W210 E55 Jacking Point Cover

    My E55 W210 facelift model is missing the passenger side front jacking point cover! They cost £40 + vat from Mercedes so unless I can find one elsewhere I will just have to order one from them. Happy to pay a reasonable price if anybody has one to sell! Cheers in advance Pat
  17. R

    At what point do you call it a day?

    Shall I put (formerly) beloved S203 out to grass? Took her in to the dealer for service today – I know it’s daft taking an oldish car to the dealer but they’re convenient and do a not-bad price and with it only needing service every 2yrs I feel it’s worth it to keep Mobilo. Also, while there...
  18. Gledsyc63

    Snap on tools + blue point

    1 3/8 80 tooth ratchet good condition 1 3/8 fod 30 tooth ratchet excellent condition 1 1/4 tm830 30 tooth ratchet ok condition 2 blue point extensions 3 inch and 6 inch http://www.ebay.co.uk/ulk/itm/201473385862 £95 including postage
  19. optimusprime

    For sale M/B Repair jack point

    Hi these four items i have for sale see picture .Check your number before you purchase please. Purchased these to do my jacking points but never used them .The part is to thick to do simple repair to jack holes on w124 .. M/B no longer make the part for my repair .. This is the thick plate...
  20. 190

    Is there any point retro-fitting LED's

    I mean any point retrofitting LED's from an energy saving perspective. From what I can gather if I replace a filament bulb with a standard LED the bulb failure warning system won't recognize the LED as it draws insufficient current. There are LED's with additional parallel resistors to...
Back
Top Bottom