sensor

Hi Just about to change front discs and pads on my 2007 E220 estate and I've noticed there is only cabling on drivers side for brake wear indicator, is this normal as Haynes manual seems to indicate they should be on both sides. Thanks in advance Rob

2004 (facelift) W203 C270 Cdi Hi. I am looking for some help..... I recently had my engine management light come on and the car went into limp mode. I had the codes read and it turned out to be the MAF sensor. I purchased a Pierburg replacemment after reading here that the cheap ebay...

Hi All, Engine has randomly cut out twice now and reading errors tell me its the crank position sensor (code 052). in order to solve the problem that I've had twice now, it was a simple case of disconnecting and reconnecting the battery. So, is it a simple case of changing the sensor or is...

For the second time my CLK 320 W209 2003 model has cut out. It restarted later, first time I had to wait about 15 minutes, second time about 10 mins. Feelings are this is the crank position sensor. I don't have much spare time at the weekend but my plan was to replace the sensor. Do you...

I need to replace my front brakes but I now getting confused of what to get. I currently have all stock brakes, but after looking on car parts 4 less there seems to be loads of options, I like the look of the drilled discs but theres different diameters showing for my car, will both sizes fit ...

Hey guys, I have a W204 c200 CDI. 2007 Can anyone help? Cut the story short. A/c wasn't working. Had it gassed and serviced and still wasn't working. Friend at Mercedes put it on Star and found out it is the refrigerant pressure sensor. Wheel nut shaped with thread one end and wire...

Hi, can anyone confirm if this is the correct plug for the seat sensor (as indicated by the red arrow pointing down, apologies for the upward one!)? Trying to fit an emulator which comes with a female socket - supplier insists this correct, but given that the outgoing socket is also female it...

Folks Not a Merc but the same principle. Please bear with me, I need help. I have a 3.5 V6 Petrol - SWB Mitsubishi Pajero. It had a head gasket failure. Off it went to have the Gaskets replaced along with: New Water Pump New Timing/Cam Belt New Crank Shaft Pulley (these de-laminate so need...

Hi all, Does anyone know how to rewire the switches for the heated seats / parking sensor? I have removed the Audio 20 head unit and switch panel so I can install a double din unit but would like to rewire the switches to different locations instead of them all being on the same board...

Curious to know if any one has had a distronic sensor fitted on there cl w216 And if so at what cost many thanks reiss

I think I have a problem with one of the ABS/Speed sensors. ESP inoperative and cruise control not working. If I replace the sensors will I still need to get the fault erased or will this happen automatically?

Guys Any ideas what the part number is for the sensor that sits on the top of the nearside airbox?

Guys I recently had an issue of VERY violent "kangarooing" when I floored it, this caused an error code to be logged "Exhaust backpressure sensor ..............too low". I had the can in at the local Indy today, they said the exhaust back pressure sensor is in the top of the turbo. As...

I have an ML250 Bluetec which I purchased in May 2012. It has done 46,000 miles. In March 2015 I had it in for a service. I noticed immediately that there was a constant smell of fuel. After a few days I spotted large puddles of fuel where the car had been parked. I took the car back in 5 days...

Hi, I'm having trouble with the coolant temperature reading on my CLC. It's stickin at 90, even when the engine is cold. I'm going to replace the sensor as this seems logical, does anyone have the location of this sensor on the engine? Ollie

Hi, Recently got a CPS code P2034 and another code P20A2 on my w211 e55. P20A2 when ZAS is turned off,some cylinder exhaust valve not work.;GERMANY Does anybody know if the second code is caused by the faulty CPS or is it a different problem altogether?

Anyone know the best place for one? When I search ebay, they all come up just under the chassis code and year, but are they all the same? Even the diesels have the same pedal/sensor? Or are they just being listed wrong? Thanks

I have a 2006 CLK 280 Conv. When the wipers are set to auto mode all it takes is the slightest drizzle and the wipers go mental operating at full speed. Is there any way the sensitivity can be adjusted, I drive a Mercedes lorry at work and this is doable through the menu settings. Many...

Hi I've just replaced my o2 sensor. Do I need to tell the ecu it's had a new one via star? Don't think so but know you have to with new airfilters! This is how I know o2 was duff when I had it on star having airfilters reset.

Is this the first signs that the crankshaft position sensor is going? The car had been driven and was parked for 1 hour, on return, when I tried to start it, all I got was the engine turning over. It's the first time it's ever occurred. I quickly turned off the engine and it started as normal...