C63 jacking points

[Felstmiester]

Two either side. I can see one in center under engine but is there one in center at the back?? Heard some people jack from center of rear diff but can't do this because of cooling fins, not that I'd do it anyway.

 

[Felstmiester]

After a lot of searching found this.

Jack for C63 - Page 2 - MBWorld.org Forums

 

[Dieselman]

Are the blocks the lift pads are lifting by, not the additional jack points?

 

[DuncS3]

I found that thread a while back - I used it to guide me. I haven't lifted the car completely of the ground but when taking my wheels off, I jack using the side jack points on one side (using my own jack), then stick another jack under the front jack point under the engine shown in the thread you linked to, for stability. For the rears I just use the standard jack points.

Dunc

 

[Felstmiester]

Are the blocks the lift pads are lifting by, not the additional jack points?

There are only 5 jack points on the 204. 2 on each side front and rear and the one under engine in center shown in the link. You can use a standard trolley jack on the jack points as the cup on the jack rests on each end of the oem jack blocks. My problem was how to get a axle stand on each corner but the post in the link has solved this. I hope!! I'll have another go tomorrow