Sprinter loses warm air after changing heater panel bulbs.

[ringway]

I replaced the heater panel illumination bulbs on the Sprinter.

Everything seemed okay but I no longer have any heat from the heater.

The right hand knob in the picture is the temperature control and is connected to a cable that I assume opens a flap to allow the hot air in from the engine. The control felt a loose on the cable after the bulb change but after experimenting I have the tension back to somewhere near normal.

Does anyone know where the flap is located?

Or perhaps I have disturbed or broken part of the heater mechanism.

Checked relevant fuses and both are okay.

Any help much appreciated.

Paul.

 

[bennesspipers]

Its your 'O' valve playing up, part of the 'Wahey' solenoid,situated next to the giggle pin on the undergearbox kickstart.

 

[welland99]

What time is it?

:What's gone wrong with the times of the posts on this thread? They seem to be an hour out.

For info, I'm posting this at 19:14.

 

[welland99]

And just as my post shows in the thread, the times of the 1st two posts lose an hour.

 

[ringway]

Its your 'O' valve playing up, part of the 'Wahey' solenoid,situated next to the giggle pin on the undergearbox kickstart.

You cheeky git!