error

hi there iv just got this problem on my 2003 c270 cdi ,when you hit kickdown i get a epc light flash then go away ,so i dont get any kickdown power ,but if i put my foot down to the point just before kickdown button endless power , any help will be appreciated many thanks scott

Error message p2553 Throttle/fuel inhibit circuit range/performance. Can anyone shed any light on what this might be?

Guys I am having this error on my merc ... What is this code relating to ... Any thoughts??

Bought a tatty 2002 Vito 108cdi to do one job and then pass it on to someone else. Drove ok for first 100 miles, except for (only) key snapping 50 miles from home and needing replacement (by mobile service). Completed journey ok. Next day no starter on key-turn. All dash lights come on...

Hi all, Just looking for a bit of advise and recommendation... The engine warning light has come on my 56 Reg C180k. Not sure exactly why, the only thing I can think is that my friend who took it for a spin was using the tiptronic gearshift and dropped down from 4-3-2 too quickly. This caused...

Hi all, I got the following code up just this evening when I took the car out. - 0715 Input/turbine speed sensor circuit malfunction Any ideas what this means or if its a big job to fix?

Hi Everybody ,I have a 2006 3.0cdi lwb viano , brought Nov 2013,v happy with it ,but not so happy with a few ongoing electronic niggles. Since buying it ,the engine check lamp has been coming on intermittently ,with the consequent gutless engine response and no kickdown. But after about 60 or so...

If a car has for an example a SRS error when it is read by star does it tell you the date at which the error occurred?

Hello guys, Some days ago, I was performing the maps update of my NTG4 to version v11 2013. At 58% of the update, the system requires the DVD #1. I take out the DVD 1b, and insert DVD 1a, but...... the comand says: "disc unreadable". The same DVD 1a, which I have used to start the update...

Hi, Just getting rid of a few gremlins. 1. When switched to automatic mode the lights stay on all of the time 2. The auto rain sensor doesn't work. These are the codes that show up. B1090 Stored Component B32/1 stored Auto light switch has open circuit or component B38/2...

I have 2010 S212 E220 estate and had a tear in drivers seat repaired yesterday at a car upholsters. fixed the tear nicely but in taking the seat out they have set off an error message (along the lines of drivers air bag faulty/malfunction). It appears all the cables have been clicked in...

I have some aftermarket projector headlights and their designed to take hids but the vito van apparently has a sensitive canbus system... so just need to know which 35w H1 canbus kit? or do i need to stick close to original wattage of 55w? canbus or non-canbus? to stop any error messages...

Hi can anyone advise how to repair this error? Is it the compressor? If so can it be repaired or is it a new unit? Also does anyone know of a reputable garage near the Burnley area. Grover

please help this is getting annoying now the time elapsed on my trip computer has stopped working on the after start section still works on after reset but its sending my mpg all over the place as there is no way in getting 87mpg driving in London

Hi all, New to the forum and to Mercs, recently bought a 2003 C220 2.2 Auto. Runs really well bar a couple of minor issues. Took it into my local garage today for a look over and came up with a load of error codes. He wasn't sure if they were stored codes or historical and not cleared (if I've...

hi all again, I knew there was an error with my maf, but last night it showed an engine check light, connected the obd reader up and error P0101 came up, as usual the car is a w203 C200 kompressor, what is the usual fix for this? Thanks.

Whenever I start my cl500 I get a fault for rear left indicator. Turn sinal flashes quicker. On checking outside all working. Bulbs all look fine too. Any ideas. Annoying as when driving error stays on so other information cannot be used

Hi Guys, I having recently bought a mercedes CLS from 2006 plugged my code reader into it. It's a fairly generic bit of code reader and doesn't do anything too fancy I don't reckon. I get a total of three errors when I run a DTC scan. Attached images. Can you tell me if this is a really...

Hi Guys, Hoping someone can point me in the right direction as i think my error codes have a common denominator.......here goes!!!!!!! Originally had no error codes, but no power/limp home mode, plugged in diagnostics, showed fault as the common swirl valve motor. Replaced motor with no...

I have an intermittent ABS and BAS/ASR error light fault. When these show up with the engine running my vario roof also wont operate, the switch lamp just flashes. The error lights sometimes go out whist driving. Any clues please.