fault

I have a 2006 Mercedes s class that has gone in limp mode rn and is giving hard shift. The fault code is see on scanning the car is 2716 When I tried to clear the fault with my mechanic it did go out of limp mode for a bit and start working properly but post 2 hrs after turning it on again...

Like a few others I was getting an error warning from my drivers side front parktronic system (really annoying) would go off as soon as I reduced speed enough to engage it,guaranteed to happen within a few hundred yards . It would happen in dry or wet conditions so today I decided to jump in and...

Hi all Started getting the EML light on and read the above code with My code reader on ipad, and changed the MAF for a new one from Euro car parts. Car ran fine with no loss of power on the old Maf and still runs fine on the new one but he EML came back on today a whole day after the new MAF...

Hi All Did a check on my car yesterday 2005 220CDI and had fault code of P2134 any advice on what to look for and how to put right. Thanks Norman

Hello Please could you give me some advice on the following fault: Rear wiper only moves in 90 degrees "steps" when set on intermittent. When on wash/wipe mode seems to behave normally. Visual check of motor looks Ok. I have cleaned all electrical connections to motor and relay...

Ok so had this A class a week drove it about 100 mile and now getting transmission message "visit workshop" and going into limp mode drives ok some days also drives ok in manual mode its got the 722.9 transmission and i'm aware of the issues they have and "ecutesting repair service". I found...

hi guys really need some help. i have a e320 cdi v6 and it was running perfect. 2005 55 i have performed the inlet port motor bypass 5 years ago with no issues. 2 weeks ago some clever **** decided to use my turbo actutor on another car to test for a fault. that other car has now been sold and...

Hi all, Hopefully someone can point me in the right direction here. I have an old w210 e430 in the barn. I left the key in the ignition when the car was in the barn for about 3 months, and the battery obviously went flat. Put on a new battery (fully charged), and the key now does...

Hi folks Got the white "Service Brake Visit Workshop" message on the dash every now and then. Read the codes and I'm getting: C1419 Check component L6/1 (left front speed sensor) C147A Check component L6/3 (left rear speed sensor) 2403 No CAN message from N47-5 2401 No CAN message from N47-B...

Can any one recommend a fault code reader for my 1998 c280? one that does it all, reads /clears codes , service light and so on. thanks, matthew.

Hello all, My car is throwing up a fault saying it cannot communicate with the sun sensor in the bonnet. I have ordered up the part and it seems to be a straight forward swap out but do I need to connect the car to Star to clear the fault or assuming that the new part solves the problem will...

I have a 55 reg clk 270 cdi which has various faults that show up on the dash but some of them are false! low water in washer bottle but the washer bottle is full, low water in radiator but the radiator is full ! I am thinking that they maybe faulty sensors but I do not want to buy them if they...

Hello, Hopefully someone might be able to help me on this. My ML developed a fault last week, BAS ESP, ETS and ABS lights came on followed shortly by the EPC light. It's an 04 ML270, 170k miles. New battery few months ago, no other faults before this. After a quick search on the...

Hi guys, AC not worked for while in my Vito W639 120cdi, suddenly stopped blowing cold & compressor does not turn on, checked fault codes, not sure what 2nd code means but 1st says faulty Refrigerant Pressure Sensor. Shall I replace the sensor or could this code have been triggered...

Hi, I have a 1992 300sl , engine sounds as sweet as ever , no oil or water loss , but occasionally when driving the oil pressure gauge drops completely and the red light comes on , if I ease off the accelerator the gauge rises again to where it should be , it could then drive all day without it...

Engine light came on and using a OBD2 adapter found the fault code P0101 (Mass Air Flow sensor?) Any ideas what's going on with my W246?

Hi Guys, Took my car C63s, to the dealer last week for a transmission software upgrade, door handle replaced and the stop start never seeming to activate, A on dash always yellow. Picked up Thursday and told all fixed. The stop start worked on the way home. Today I drove 40 miles, all the...

2004 van (215k miles), the ecu/fusebox fan seems to be sticking on and flattening battery, managed to find and unplug the fan. (unscrew fuseboard lift it up and on the vertical piece on left side below you will see red and brown wires twisted round each other into a plug, pull that its the power...

Afternoon I have an issue on a 2003 C230K coupe (40k miles) The automatic gearbox seems to not be changing correctly - best described as jerky/lurching occasionally (at its worst it almost feels like the car rocks when it goes into gear, if that makes sense!) It's recently had a fluid change...

hello MB world.... i need some help/advice please....recently my engine management light came on, took it straight to the garage to check the fault and was told it was the AIR FLOW MASS, which i then brought from euro car part the VOD Siemens one, got that changed and coded in, but then within...